Nonstop flight route between Escanaba, Michigan, United States and Grand Forks, North Dakota, United States:
Departure Airport:
Arrival Airport:
Distance from ESC to RDR:
Share this route:
Jump to:
- About this route
- ESC Airport Information
- RDR Airport Information
- Facts about ESC
- Facts about RDR
- Map of Nearest Airports to ESC
- List of Nearest Airports to ESC
- Map of Furthest Airports from ESC
- List of Furthest Airports from ESC
- Map of Nearest Airports to RDR
- List of Nearest Airports to RDR
- Map of Furthest Airports from RDR
- List of Furthest Airports from RDR
About this route:
A direct, nonstop flight between Delta County Airport (ESC), Escanaba, Michigan, United States and Grand Forks Air Force Base (RDR), Grand Forks, North Dakota, United States would travel a Great Circle distance of 511 miles (or 822 kilometers).
A Great Circle is the shortest distance between 2 points on a sphere. Because most world maps are flat (but the Earth is round), the route of the shortest distance between 2 points on the Earth will often appear curved when viewed on a flat map, especially for long distances. If you were to simply draw a straight line on a flat map and measure a very long distance, it would likely be much further than if you were to lay a string between those two points on a globe. Because of the relatively short distance between Delta County Airport and Grand Forks Air Force Base, the route shown on this map most likely still appears to be a straight line.
Departure Airport Information:
| IATA / ICAO Codes: | ESC / KESC |
| Airport Name: | Delta County Airport |
| Location: | Escanaba, Michigan, United States |
| GPS Coordinates: | 45°43'22"N by 87°5'36"W |
| Area Served: | Escanaba, Michigan |
| Operator/Owner: | Delta County |
| Airport Type: | Public |
| Elevation: | 609 feet (186 meters) |
| # of Runways: | 2 |
| View all routes: | Routes from ESC |
| More Information: | ESC Maps & Info |
Arrival Airport Information:
| IATA / ICAO Codes: | RDR / KRDR |
| Airport Names: |
|
| Location: | Grand Forks, North Dakota, United States |
| GPS Coordinates: | 47°57'39"N by 97°24'3"W |
| View all routes: | Routes from RDR |
| More Information: | RDR Maps & Info |
Facts about Delta County Airport (ESC):
- Because of Delta County Airport's relatively low elevation of 609 feet, planes can take off or land at Delta County Airport at a lower air speed than at airports located at a higher elevation. This is because the air density is higher closer to sea level than it would otherwise be at higher elevations.
- Delta County Airport (ESC) has 2 runways.
- The furthest airport from Delta County Airport (ESC) is Margaret River Airport (MGV), which is located 11,013 miles (17,723 kilometers) away in Margaret River, Western Australia, Australia.
- The closest airport to Delta County Airport (ESC) is Sawyer International Airport (MQT), which is located 46 miles (74 kilometers) NNW of ESC.
Facts about Grand Forks Air Force Base (RDR):
- On 3 November 1967, the Department of Defense revealed that GFAFB was one of 10 initial locations to host a Sentinel Anti-Ballistic Missile site.
- In addition to being known as "Grand Forks Air Force Base", another name for RDR is "Grand Forks AFB".
- The closest airport to Grand Forks Air Force Base (RDR) is Grand Forks International Airport (GFK), which is located only 10 miles (17 kilometers) E of RDR.
- On 1 November 1964, 321st Strategic Missile Wing was organized as the Minuteman II intercontinental ballistic missile wing at GFAFB, the first in SAC.
- In October 1977, the PAR came under operational control of the USAF, which operated it thereafter as part of its early warning system.
- In 1973, the 319th Bomb Wing acquired the AGM-69 Short Range Attack Missile, replacing the older AGM-28 Hound Dog air-to-ground missile aboard its B-52H aircraft.
- The furthest airport from Grand Forks Air Force Base (RDR) is Margaret River Airport (MGV), which is located 10,504 miles (16,904 kilometers) away in Margaret River, Western Australia, Australia.
- Grand Forks Air Force Base was established on 1 December 1955, with construction beginning in the fall of that year.
