Nonstop flight route between Pellston, Michigan, United States and Columbus, Ohio, United States:

About this route:

A direct, nonstop flight between Pellston Regional Airport of Emmet County (PLN), Pellston, Michigan, United States and Port Columbus International Airport (CMH), Columbus, Ohio, United States would travel a Great Circle distance of 397 miles (or 639 kilometers).

A Great Circle is the shortest distance between 2 points on a sphere. Because most world maps are flat (but the Earth is round), the route of the shortest distance between 2 points on the Earth will often appear curved when viewed on a flat map, especially for long distances. If you were to simply draw a straight line on a flat map and measure a very long distance, it would likely be much further than if you were to lay a string between those two points on a globe. Because of the relatively short distance between Pellston Regional Airport of Emmet County and Port Columbus International Airport, the route shown on this map most likely still appears to be a straight line.

Departure Airport Information:

Arrival Airport Information:

Facts about Pellston Regional Airport of Emmet County (PLN):

• Pellston Regional Airport of Emmet County (PLN) has 2 runways.
• The furthest airport from Pellston Regional Airport of Emmet County (PLN) is Margaret River Airport (MGV), which is located 11,115 miles (17,888 kilometers) away in Margaret River, Western Australia, Australia.
• In May 2013 Lakeshore Express Aviation announced regular flights from Pellston to Oakland County International Airport on 30-seat Saab 340B aircraft beginning in June.
• Because of Pellston Regional Airport of Emmet County's relatively low elevation of 720 feet, planes can take off or land at Pellston Regional Airport of Emmet County at a lower air speed than at airports located at a higher elevation. This is because the air density is higher closer to sea level than it would otherwise be at higher elevations.
• Mainly a general aviation airport, Pellston Regional Airport also functions as the primary commercial airport for the sparsely populated northern tip of Michigan's Lower Peninsula, owing to its location halfway between the region's primary cities, Petoskey and Cheboygan, as well as its close proximity to the tourist centers of Mackinaw City and Mackinac Island.
• The closest airport to Pellston Regional Airport of Emmet County (PLN) is Mackinac Island Airport (MCD), which is located 22 miles (35 kilometers) NNE of PLN.
• The 35,000 square feet northern lodge themed passenger terminal building was constructed in 2003 and designed by architect Paul W.

Facts about Port Columbus International Airport (CMH):

• Because of Port Columbus International Airport's relatively low elevation of 815 feet, planes can take off or land at Port Columbus International Airport at a lower air speed than at airports located at a higher elevation. This is because the air density is higher closer to sea level than it would otherwise be at higher elevations.
• The closest airport to Port Columbus International Airport (CMH) is Ohio State University Airport (OSU), which is located only 11 miles (18 kilometers) WNW of CMH.
• On October 21, 2010, a new arrivals/departures board was installed in the place of the old one in the main entrance area
• An American Airlines Convair CV-240 from Dayton International Airport was on approach to Runway 27 at 300 feet when the left side of the plane collided with a US Navy Beechcraft SNB-2C Navigator, also on approach.
• The original 1929 layout for the airport covered 524 acres, with two runways 2,500 and 3,500 feet long.
• The diagram on the February 1951 Coast & Geodetic Survey instrument-approach chart shows runways 006/186 3550 ft long, 052/232 4400 ft, 096/276 4500 ft, and 127/307 5030 ft.
• Port Columbus International Airport (CMH) has 2 runways.
• The furthest airport from Port Columbus International Airport (CMH) is Margaret River Airport (MGV), which is located 11,361 miles (18,284 kilometers) away in Margaret River, Western Australia, Australia.