Nonstop flight route between Windsor Locks (near Hartford), Connecticut, United States and Hobart, Tasmania, Australia:

About this route:

A direct, nonstop flight between Bradley International Airport (BDL), Windsor Locks (near Hartford), Connecticut, United States and Hobart International Airport (HBA), Hobart, Tasmania, Australia would travel a Great Circle distance of 10,404 miles (or 16,744 kilometers).

A Great Circle is the shortest distance between 2 points on a sphere. Because most world maps are flat (but the Earth is round), the route of the shortest distance between 2 points on the Earth will often appear curved when viewed on a flat map, especially for long distances. If you were to simply draw a straight line on a flat map and measure a very long distance, it would likely be much further than if you were to lay a string between those two points on a globe. Because of the large distance between Bradley International Airport and Hobart International Airport, the route shown on this map most likely appears curved because of this reason.

Try it at home! Get a globe and tightly lay a string between Bradley International Airport and Hobart International Airport. You'll see that it will travel the same route of the red line on this map!

Departure Airport Information:

Arrival Airport Information:

Facts about Bradley International Airport (BDL):

• In December 2002, a new International Arrivals Building opened to the west of Terminal B.
• In 1979, a tornado ripped through Windsor Locks, wreaking destruction along the eastern portions of the airport.
• Because of Bradley International Airport's relatively low elevation of 173 feet, planes can take off or land at Bradley International Airport at a lower air speed than at airports located at a higher elevation. This is because the air density is higher closer to sea level than it would otherwise be at higher elevations.
• The closest airport to Bradley International Airport (BDL) is Rentschler Heliport (EHT), which is located only 13 miles (21 kilometers) SSE of BDL.
• The furthest airport from Bradley International Airport (BDL) is Margaret River Airport (MGV), which is located 11,740 miles (18,894 kilometers) away in Margaret River, Western Australia, Australia.
• Bradley International Airport (BDL) has 3 runways.
• The airfield began civilian use in 1947 as Bradley International Airport.
• The airport is about halfway between Hartford and Springfield.
• On June 22, 2012, the Connecticut Airport Authority board formally approved the hiring of Kevin A.

Facts about Hobart International Airport (HBA):

• During April 2007, the Hobart Airport's public relations firm confirmed they had submitted plans of the project to the Federal Government for assessment.
• Because of Hobart International Airport's relatively low elevation of 13 feet, planes can take off or land at Hobart International Airport at a lower air speed than at airports located at a higher elevation. This is because the air density is higher closer to sea level than it would otherwise be at higher elevations.
• Hobart International Airport handled 1,855,849 passengers last year.
• The furthest airport from Hobart International Airport (HBA) is Corvo Airport (CVU), which is nearly antipodal to Hobart International Airport (meaning Hobart International Airport is almost on the exact opposite side of the Earth from Corvo Airport), and is located 12,207 miles (19,645 kilometers) away in Corvo Island, Azores, Portugal.
• The current domestic terminal was opened in 1976, and has been expanded several times since then.
• The majority of Hobart's general aviation traffic makes use of the nearby Cambridge Aerodrome, which was sold in 1999 on the condition that it remain an airport until 2004.
• The closest airport to Hobart International Airport (HBA) is Launceston Airport (LST), which is located 91 miles (146 kilometers) N of HBA.
• Hobart International Airport (HBA) currently has only 1 runway.
• Prior to the existence of the airport, the region was served by Cambridge Airport, a small airport located close to the existing site.