Nonstop flight route between Wahpeton, North Dakota, United States and Bellingham, Washington, United States:

About this route:

A direct, nonstop flight between Harry Stern Airport (WAH), Wahpeton, North Dakota, United States and Bellingham International Airport (BLI), Bellingham, Washington, United States would travel a Great Circle distance of 1,217 miles (or 1,958 kilometers).

A Great Circle is the shortest distance between 2 points on a sphere. Because most world maps are flat (but the Earth is round), the route of the shortest distance between 2 points on the Earth will often appear curved when viewed on a flat map, especially for long distances. If you were to simply draw a straight line on a flat map and measure a very long distance, it would likely be much further than if you were to lay a string between those two points on a globe. Because of the relatively short distance between Harry Stern Airport and Bellingham International Airport, the route shown on this map most likely still appears to be a straight line.

Departure Airport Information:

Arrival Airport Information:

Facts about Harry Stern Airport (WAH):

• Harry Stern Airport covers an area of 585 acres at an elevation of 968 feet above mean sea level.
• The furthest airport from Harry Stern Airport (WAH) is Margaret River Airport (MGV), which is located 10,574 miles (17,018 kilometers) away in Margaret River, Western Australia, Australia.
• The closest airport to Harry Stern Airport (WAH) is Fergus Falls Municipal Airport (FFM), which is located 22 miles (35 kilometers) E of WAH.
• In addition to being known as "Harry Stern Airport", another name for WAH is "BWP".
• Harry Stern Airport (WAH) has 2 runways.
• Because of Harry Stern Airport's relatively low elevation of 968 feet, planes can take off or land at Harry Stern Airport at a lower air speed than at airports located at a higher elevation. This is because the air density is higher closer to sea level than it would otherwise be at higher elevations.

Facts about Bellingham International Airport (BLI):

• In addition to being known as "Bellingham International Airport", another name for BLI is "(Bellingham/Tulip Army Airfield)".
• Because of Bellingham International Airport's relatively low elevation of 170 feet, planes can take off or land at Bellingham International Airport at a lower air speed than at airports located at a higher elevation. This is because the air density is higher closer to sea level than it would otherwise be at higher elevations.
• In 1936 Whatcom County obtained 200 acres for an airport at the current airport site.
• Bellingham International Airport (BLI) currently has only 1 runway.
• The early 21st century saw rapid expansion at the Bellingham International Airport from multiple large air carriers motivated by the potential passenger loads from lower mainland British Columbia.
• In 1940 the United States Army Corps of Engineers took over the facility and expanded it to three full runways, revetments for parking aircraft, and development of personnel quarters.
• In September 2010 the airport completed a $26 million resurfacing of the runway to allow aircraft up to the size of Boeing 757s to utilize the airport.
• The Washington Air National Guard occupies a 7.5-acre site at Bellingham International Airport.
• The closest airport to Bellingham International Airport (BLI) is Blaine Municipal Airport (BWS), which is located only 16 miles (26 kilometers) NNW of BLI.
• The furthest airport from Bellingham International Airport (BLI) is Tôlanaro Airport (FTU), which is located 10,700 miles (17,220 kilometers) away in Tôlanaro, Madagascar.