Nonstop flight route between Bainbridge, Georgia, United States and Dothan, Alabama, United States:

About this route:

A direct, nonstop flight between Decatur County Industrial Air Park (BGE), Bainbridge, Georgia, United States and Dothan Regional Airport (DHN), Dothan, Alabama, United States would travel a Great Circle distance of 54 miles (or 86 kilometers).

A Great Circle is the shortest distance between 2 points on a sphere. Because most world maps are flat (but the Earth is round), the route of the shortest distance between 2 points on the Earth will often appear curved when viewed on a flat map, especially for long distances. If you were to simply draw a straight line on a flat map and measure a very long distance, it would likely be much further than if you were to lay a string between those two points on a globe. Because of the relatively short distance between Decatur County Industrial Air Park and Dothan Regional Airport, the route shown on this map most likely still appears to be a straight line.

Departure Airport Information:

Arrival Airport Information:

Facts about Decatur County Industrial Air Park (BGE):

• Following entry of the United States into World War II, the Chief of the Army Air Corps directed the Air Corps Flying Training Command Southeast Training Center to immediately take action to select air base sites needed to increase its pilot training rate to meet anticipated wartime demands.
• The closest airport to Decatur County Industrial Air Park (BGE) is Tallahassee Regional Airport (TLH), which is located 43 miles (70 kilometers) SSE of BGE.
• Because of Decatur County Industrial Air Park's relatively low elevation of 141 feet, planes can take off or land at Decatur County Industrial Air Park at a lower air speed than at airports located at a higher elevation. This is because the air density is higher closer to sea level than it would otherwise be at higher elevations.
• As a result of the Korean War which began in 1950 and the expansion of the United States Air Force, Bainbridge Air Base* was reopened to train additional pilots.
• The furthest airport from Decatur County Industrial Air Park (BGE) is Kalbarri Airport (KAX), which is located 11,278 miles (18,150 kilometers) away in Kalbarri, Western Australia, Australia.
• Decatur County Industrial Air Park (BGE) has 2 runways.
• During World War II, the airfield conducted flight training of new pilots by Army Air Forces Flying Training Command.

Facts about Dothan Regional Airport (DHN):

• The closest airport to Dothan Regional Airport (DHN) is Hanchey Army Heliport (AHP) (HEY), which is located only 12 miles (20 kilometers) W of DHN.
• Because of Dothan Regional Airport's relatively low elevation of 401 feet, planes can take off or land at Dothan Regional Airport at a lower air speed than at airports located at a higher elevation. This is because the air density is higher closer to sea level than it would otherwise be at higher elevations.
• Dothan Regional Airport (DHN) has 2 runways.
• In addition to being known as "Dothan Regional Airport", another name for DHN is "(former Napier Army Airfield)".
• The furthest airport from Dothan Regional Airport (DHN) is Margaret River Airport (MGV), which is located 11,230 miles (18,072 kilometers) away in Margaret River, Western Australia, Australia.
• The 29th Flying Training Wing was activated at Napier on December 26, 1942.