Nonstop flight route between Bankstown (near Sydney), New South Wales, Australia and Bellingham, Washington, United States:

About this route:

A direct, nonstop flight between Bankstown Airport (BWU), Bankstown (near Sydney), New South Wales, Australia and Bellingham International Airport (BLI), Bellingham, Washington, United States would travel a Great Circle distance of 7,788 miles (or 12,534 kilometers).

A Great Circle is the shortest distance between 2 points on a sphere. Because most world maps are flat (but the Earth is round), the route of the shortest distance between 2 points on the Earth will often appear curved when viewed on a flat map, especially for long distances. If you were to simply draw a straight line on a flat map and measure a very long distance, it would likely be much further than if you were to lay a string between those two points on a globe. Because of the large distance between Bankstown Airport and Bellingham International Airport, the route shown on this map most likely appears curved because of this reason.

Try it at home! Get a globe and tightly lay a string between Bankstown Airport and Bellingham International Airport. You'll see that it will travel the same route of the red line on this map!

Departure Airport Information:

Arrival Airport Information:

Facts about Bankstown Airport (BWU):

• The closest airport to Bankstown Airport (BWU) is Sydney (Kingsford Smith) Airport (SYD), which is located only 11 miles (18 kilometers) E of BWU.
• Bankstown Airport (BWU) has 3 runways.
• In 1970 the government put forth a proposal to expand the airport's operations but this was vigorously opposed by the local community.
• The airport has three runways.
• On 26 September 2011, a Cessna 152 registered VH-HCE and operated by Basair Pty Ltd experienced total power loss due to fuel contamination with water.
• In addition to being known as "Bankstown Airport", another name for BWU is "Sydney/Bankstown Airport".
• The airport offers a range of aviation and non-aviation settings with large hangars to accommodate grand scale indoor filming.
• Bankstown has its own dedicated air traffic control tower, operated by Airservices Australia, and uses Class D airspace procedures.
• The furthest airport from Bankstown Airport (BWU) is Santa Maria Airport (SMA), which is nearly antipodal to Bankstown Airport (meaning Bankstown Airport is almost on the exact opposite side of the Earth from Santa Maria Airport), and is located 12,135 miles (19,529 kilometers) away in Santa Maria, Portugal.
• Because of Bankstown Airport's relatively low elevation of 34 feet, planes can take off or land at Bankstown Airport at a lower air speed than at airports located at a higher elevation. This is because the air density is higher closer to sea level than it would otherwise be at higher elevations.

Facts about Bellingham International Airport (BLI):

• The airport is presently undergoing a significant expansion to the commercial passenger terminal building which will increase the size of the terminal building from 27,000 to 85,000 square feet.
• The USAAF closed the facility in September 1946, and it was turned over to the War Assets Administration for disposal.
• Bellingham International Airport (BLI) currently has only 1 runway.
• The closest airport to Bellingham International Airport (BLI) is Blaine Municipal Airport (BWS), which is located only 16 miles (26 kilometers) NNW of BLI.
• The Washington Air National Guard occupies a 7.5-acre site at Bellingham International Airport.
• In response to the increased low fare competition offered by Allegiant in their home state, Alaska Airlines expanded service from Bellingham International.
• In addition to being known as "Bellingham International Airport", another name for BLI is "(Bellingham/Tulip Army Airfield)".
• The furthest airport from Bellingham International Airport (BLI) is Tôlanaro Airport (FTU), which is located 10,700 miles (17,220 kilometers) away in Tôlanaro, Madagascar.
• Because of Bellingham International Airport's relatively low elevation of 170 feet, planes can take off or land at Bellingham International Airport at a lower air speed than at airports located at a higher elevation. This is because the air density is higher closer to sea level than it would otherwise be at higher elevations.