Nonstop flight route between Melbourne, Victoria, Australia and Bellingham, Washington, United States:

About this route:

A direct, nonstop flight between Melbourne Airport (MEL), Melbourne, Victoria, Australia and Bellingham International Airport (BLI), Bellingham, Washington, United States would travel a Great Circle distance of 8,217 miles (or 13,224 kilometers).

A Great Circle is the shortest distance between 2 points on a sphere. Because most world maps are flat (but the Earth is round), the route of the shortest distance between 2 points on the Earth will often appear curved when viewed on a flat map, especially for long distances. If you were to simply draw a straight line on a flat map and measure a very long distance, it would likely be much further than if you were to lay a string between those two points on a globe. Because of the large distance between Melbourne Airport and Bellingham International Airport, the route shown on this map most likely appears curved because of this reason.

Try it at home! Get a globe and tightly lay a string between Melbourne Airport and Bellingham International Airport. You'll see that it will travel the same route of the red line on this map!

Departure Airport Information:

Arrival Airport Information:

Facts about Melbourne Airport (MEL):

• Expansion of carparks has also continued with a $40 million project commenced in 2004, doubling the size of the short term carpark with the addition of 2,500 spaces over six levels, along with 1,200 new spaces added to the 5,000 already available in the long term carpark.
• The closest airport to Melbourne Airport (MEL) is Essendon Airport (MEB), which is located only 5 miles (8 kilometers) SE of MEL.
• In addition to being known as "Melbourne Airport", another name for MEL is "Tullamarine Airport".
• Melbourne Airport handled 2,998,000 passengers last year.
• Terminal 3 – opened with the airport as the Ansett Australia terminal, but is now owned by Melbourne Airport.
• In late 1989, Federal Airports Corporation Inspector A.
• Terminal 1 hosts domestic services for Qantas Group airlines, Qantas, Jetstar and QantasLink and is located to the northern end of the building.
• In May 1959 it was announced that a new airport would be built at Tullamarine, with Prime Minister Robert Menzies announcing on 27 November 1962 a five-year plan to provide Melbourne with a A$45 million "jetport" by 1967.
• The furthest airport from Melbourne Airport (MEL) is Flores Airport (FLW), which is nearly antipodal to Melbourne Airport (meaning Melbourne Airport is almost on the exact opposite side of the Earth from Flores Airport), and is located 12,187 miles (19,613 kilometers) away in Flores Island, Azores, Portugal.
• Because of Melbourne Airport's relatively low elevation of 434 feet, planes can take off or land at Melbourne Airport at a lower air speed than at airports located at a higher elevation. This is because the air density is higher closer to sea level than it would otherwise be at higher elevations.
• Melbourne Airport (MEL) has 2 runways.

Facts about Bellingham International Airport (BLI):

• In early 2007 Bellingham International hosted service to three destinations by the short-lived Western Airlines.
• In the 1990s homes were purchased to extend the runway in an effort to attract air carriers.
• Bellingham International Airport (BLI) currently has only 1 runway.
• The furthest airport from Bellingham International Airport (BLI) is Tôlanaro Airport (FTU), which is located 10,700 miles (17,220 kilometers) away in Tôlanaro, Madagascar.
• In September 2010 the airport completed a $26 million resurfacing of the runway to allow aircraft up to the size of Boeing 757s to utilize the airport.
• The closest airport to Bellingham International Airport (BLI) is Blaine Municipal Airport (BWS), which is located only 16 miles (26 kilometers) NNW of BLI.
• Because of Bellingham International Airport's relatively low elevation of 170 feet, planes can take off or land at Bellingham International Airport at a lower air speed than at airports located at a higher elevation. This is because the air density is higher closer to sea level than it would otherwise be at higher elevations.
• In addition to being known as "Bellingham International Airport", another name for BLI is "(Bellingham/Tulip Army Airfield)".
• In 1940 the United States Army Corps of Engineers took over the facility and expanded it to three full runways, revetments for parking aircraft, and development of personnel quarters.