Nonstop flight route between Bainbridge, Georgia, United States and Elmira/Big Flats, New York, United States:

About this route:

A direct, nonstop flight between Decatur County Industrial Air Park (BGE), Bainbridge, Georgia, United States and Elmira/Corning Regional Airport (ELM), Elmira/Big Flats, New York, United States would travel a Great Circle distance of 884 miles (or 1,422 kilometers).

A Great Circle is the shortest distance between 2 points on a sphere. Because most world maps are flat (but the Earth is round), the route of the shortest distance between 2 points on the Earth will often appear curved when viewed on a flat map, especially for long distances. If you were to simply draw a straight line on a flat map and measure a very long distance, it would likely be much further than if you were to lay a string between those two points on a globe. Because of the relatively short distance between Decatur County Industrial Air Park and Elmira/Corning Regional Airport, the route shown on this map most likely still appears to be a straight line.

Departure Airport Information:

Arrival Airport Information:

Facts about Decatur County Industrial Air Park (BGE):

• The furthest airport from Decatur County Industrial Air Park (BGE) is Kalbarri Airport (KAX), which is located 11,278 miles (18,150 kilometers) away in Kalbarri, Western Australia, Australia.
• Because of Decatur County Industrial Air Park's relatively low elevation of 141 feet, planes can take off or land at Decatur County Industrial Air Park at a lower air speed than at airports located at a higher elevation. This is because the air density is higher closer to sea level than it would otherwise be at higher elevations.
• During World War II, the airfield conducted flight training of new pilots by Army Air Forces Flying Training Command.
• Decatur County Industrial Air Park (BGE) has 2 runways.
• As a result of the Korean War which began in 1950 and the expansion of the United States Air Force, Bainbridge Air Base* was reopened to train additional pilots.
• Following entry of the United States into World War II, the Chief of the Army Air Corps directed the Air Corps Flying Training Command Southeast Training Center to immediately take action to select air base sites needed to increase its pilot training rate to meet anticipated wartime demands.
• The closest airport to Decatur County Industrial Air Park (BGE) is Tallahassee Regional Airport (TLH), which is located 43 miles (70 kilometers) SSE of BGE.

Facts about Elmira/Corning Regional Airport (ELM):

• The furthest airport from Elmira/Corning Regional Airport (ELM) is Margaret River Airport (MGV), which is located 11,573 miles (18,625 kilometers) away in Margaret River, Western Australia, Australia.
• General aviation facilities are in a separate terminal away from the commercial services.
• Allegiant Air operates the only scheduled mainline airliners from the airport, Airbus A320, McDonnell Douglas MD-80s.
• The closest airport to Elmira/Corning Regional Airport (ELM) is Ithaca Tompkins Regional Airport (ITH), which is located 32 miles (51 kilometers) NE of ELM.
• Elmira/Corning Regional Airport is a county-owned public airport in Chemung County, New York, seven miles northwest of Elmira and eight miles east of Corning.
• Elmira/Corning Regional Airport (ELM) has 3 runways.
• Because of Elmira/Corning Regional Airport's relatively low elevation of 954 feet, planes can take off or land at Elmira/Corning Regional Airport at a lower air speed than at airports located at a higher elevation. This is because the air density is higher closer to sea level than it would otherwise be at higher elevations.
• The airport covers 1,000 acres at an elevation of 954 feet.