Nonstop flight route between Bainbridge, Georgia, United States and Grand Forks, North Dakota, United States:

About this route:

A direct, nonstop flight between Decatur County Industrial Air Park (BGE), Bainbridge, Georgia, United States and Grand Forks Air Force Base (RDR), Grand Forks, North Dakota, United States would travel a Great Circle distance of 1,353 miles (or 2,177 kilometers).

A Great Circle is the shortest distance between 2 points on a sphere. Because most world maps are flat (but the Earth is round), the route of the shortest distance between 2 points on the Earth will often appear curved when viewed on a flat map, especially for long distances. If you were to simply draw a straight line on a flat map and measure a very long distance, it would likely be much further than if you were to lay a string between those two points on a globe. Because of the relatively short distance between Decatur County Industrial Air Park and Grand Forks Air Force Base, the route shown on this map most likely still appears to be a straight line.

Departure Airport Information:

Arrival Airport Information:

Facts about Decatur County Industrial Air Park (BGE):

• Following entry of the United States into World War II, the Chief of the Army Air Corps directed the Air Corps Flying Training Command Southeast Training Center to immediately take action to select air base sites needed to increase its pilot training rate to meet anticipated wartime demands.
• As a result of the Korean War which began in 1950 and the expansion of the United States Air Force, Bainbridge Air Base* was reopened to train additional pilots.
• Decatur County Industrial Air Park (BGE) has 2 runways.
• Because of Decatur County Industrial Air Park's relatively low elevation of 141 feet, planes can take off or land at Decatur County Industrial Air Park at a lower air speed than at airports located at a higher elevation. This is because the air density is higher closer to sea level than it would otherwise be at higher elevations.
• The furthest airport from Decatur County Industrial Air Park (BGE) is Kalbarri Airport (KAX), which is located 11,278 miles (18,150 kilometers) away in Kalbarri, Western Australia, Australia.
• The closest airport to Decatur County Industrial Air Park (BGE) is Tallahassee Regional Airport (TLH), which is located 43 miles (70 kilometers) SSE of BGE.

Facts about Grand Forks Air Force Base (RDR):

• On 18 February 1957, the 478th Fighter Group was activated at Grand Forks.
• With the restructuring of the Air Force and the disestablishment of SAC in 1992, the wing transferred to Air Combat Command, then came under Air Force Space Command in 1993.
• On 1 September 1958, the Strategic Air Command established the 4133d Strategic Wing at Grand Forks as part of its plan to disperse its B-52 heavy bombers over a larger number of bases, thus making it more difficult for the Soviet Union to knock out the entire fleet with a surprise first strike.
• The DC-11 SAGE blockhouse was later the headquarters of the SAC 321st Strategic Missile Wing.
• The furthest airport from Grand Forks Air Force Base (RDR) is Margaret River Airport (MGV), which is located 10,504 miles (16,904 kilometers) away in Margaret River, Western Australia, Australia.
• In 1973, the 319th Bomb Wing acquired the AGM-69 Short Range Attack Missile, replacing the older AGM-28 Hound Dog air-to-ground missile aboard its B-52H aircraft.
• The closest airport to Grand Forks Air Force Base (RDR) is Grand Forks International Airport (GFK), which is located only 10 miles (17 kilometers) E of RDR.
• In addition to being known as "Grand Forks Air Force Base", another name for RDR is "Grand Forks AFB".