Nonstop flight route between Columbus, Mississippi, United States and Bainbridge, Georgia, United States:

About this route:

A direct, nonstop flight between Columbus Air Force Base (CBM), Columbus, Mississippi, United States and Decatur County Industrial Air Park (BGE), Bainbridge, Georgia, United States would travel a Great Circle distance of 289 miles (or 465 kilometers).

A Great Circle is the shortest distance between 2 points on a sphere. Because most world maps are flat (but the Earth is round), the route of the shortest distance between 2 points on the Earth will often appear curved when viewed on a flat map, especially for long distances. If you were to simply draw a straight line on a flat map and measure a very long distance, it would likely be much further than if you were to lay a string between those two points on a globe. Because of the relatively short distance between Columbus Air Force Base and Decatur County Industrial Air Park, the route shown on this map most likely still appears to be a straight line.

Departure Airport Information:

Arrival Airport Information:

Facts about Columbus Air Force Base (CBM):

• The closest airport to Columbus Air Force Base (CBM) is Columbus-Lowndes County Airport (UBS), which is located only 13 miles (21 kilometers) SSE of CBM.
• In addition to being known as "Columbus Air Force Base", another name for CBM is "Columbus AFB".
• Columbus AFB has been training Air Force pilots since World War II, and that mission continues today.
• In preparation for this transfer, Air Training Command had activated the 3650th Pilot Training Wing at Columbus on 15 February.
• The furthest airport from Columbus Air Force Base (CBM) is Margaret River Airport (MGV), which is located 11,088 miles (17,844 kilometers) away in Margaret River, Western Australia, Australia.
• In 1965 the 454th converted to B-52D, which was re-engineered for conventional bomb missions over Southeast Asia, although some B-52Cs were also assigned during 1968–69.
• But while the Air Force’s pilot training requirements were decreasing, its strategic air arm was expanding.During the 1950s, Strategic Air Command wings had become extremely large.
• No one designated or suggested a name for the new base until 22 January 1942.
• On 8 January 1943, the War Department constituted and activated the 30th Flying Training Wing at Columbus and assigned it to the AAF Eastern Flying Training Command.
• About half the pilots in the Air Force today went through basic and primary flight training at Columbus AFB.

Facts about Decatur County Industrial Air Park (BGE):

• The furthest airport from Decatur County Industrial Air Park (BGE) is Kalbarri Airport (KAX), which is located 11,278 miles (18,150 kilometers) away in Kalbarri, Western Australia, Australia.
• During World War II, the airfield conducted flight training of new pilots by Army Air Forces Flying Training Command.
• The closest airport to Decatur County Industrial Air Park (BGE) is Tallahassee Regional Airport (TLH), which is located 43 miles (70 kilometers) SSE of BGE.
• The contractor broke ground on 3 April 1942, for Bainbridge Army Airfield.
• Because of Decatur County Industrial Air Park's relatively low elevation of 141 feet, planes can take off or land at Decatur County Industrial Air Park at a lower air speed than at airports located at a higher elevation. This is because the air density is higher closer to sea level than it would otherwise be at higher elevations.
• Decatur County Industrial Air Park (BGE) has 2 runways.
• Decatur County Industrial Air Park Airport covers an area of 940 acres at an elevation of 141 feet above mean sea level.