Nonstop flight route between Tifton, Georgia, United States and Bainbridge, Georgia, United States:

About this route:

A direct, nonstop flight between Henry Tift Myers Airport (TMA), Tifton, Georgia, United States and Decatur County Industrial Air Park (BGE), Bainbridge, Georgia, United States would travel a Great Circle distance of 75 miles (or 121 kilometers).

A Great Circle is the shortest distance between 2 points on a sphere. Because most world maps are flat (but the Earth is round), the route of the shortest distance between 2 points on the Earth will often appear curved when viewed on a flat map, especially for long distances. If you were to simply draw a straight line on a flat map and measure a very long distance, it would likely be much further than if you were to lay a string between those two points on a globe. Because of the relatively short distance between Henry Tift Myers Airport and Decatur County Industrial Air Park, the route shown on this map most likely still appears to be a straight line.

Departure Airport Information:

Arrival Airport Information:

Facts about Henry Tift Myers Airport (TMA):

• The airport was constructed in 1940.
• Henry Tift Myers Airport (TMA) has 2 runways.
• The furthest airport from Henry Tift Myers Airport (TMA) is Margaret River Airport (MGV), which is located 11,344 miles (18,256 kilometers) away in Margaret River, Western Australia, Australia.
• Because of Henry Tift Myers Airport's relatively low elevation of 355 feet, planes can take off or land at Henry Tift Myers Airport at a lower air speed than at airports located at a higher elevation. This is because the air density is higher closer to sea level than it would otherwise be at higher elevations.
• The closest airport to Henry Tift Myers Airport (TMA) is Spence Airport (MUL), which is located 24 miles (38 kilometers) SSW of TMA.

Facts about Decatur County Industrial Air Park (BGE):

• Decatur County Industrial Air Park Airport covers an area of 940 acres at an elevation of 141 feet above mean sea level.
• Following entry of the United States into World War II, the Chief of the Army Air Corps directed the Air Corps Flying Training Command Southeast Training Center to immediately take action to select air base sites needed to increase its pilot training rate to meet anticipated wartime demands.
• Decatur County Industrial Air Park (BGE) has 2 runways.
• The closest airport to Decatur County Industrial Air Park (BGE) is Tallahassee Regional Airport (TLH), which is located 43 miles (70 kilometers) SSE of BGE.
• The furthest airport from Decatur County Industrial Air Park (BGE) is Kalbarri Airport (KAX), which is located 11,278 miles (18,150 kilometers) away in Kalbarri, Western Australia, Australia.
• Today, Bainbridge is used for various purposes in addition to a small amount of aviation activity.
• Because of Decatur County Industrial Air Park's relatively low elevation of 141 feet, planes can take off or land at Decatur County Industrial Air Park at a lower air speed than at airports located at a higher elevation. This is because the air density is higher closer to sea level than it would otherwise be at higher elevations.