Nonstop flight route between Guernsey, Channel Islands, United Kingdom and Metlakatla, Annette Island, Alaska, United States:

About this route:

A direct, nonstop flight between Guernsey Airport (GCI), Guernsey, Channel Islands, United Kingdom and Metlakatla Seaplane Base (MTM), Metlakatla, Annette Island, Alaska, United States would travel a Great Circle distance of 4,635 miles (or 7,459 kilometers).

A Great Circle is the shortest distance between 2 points on a sphere. Because most world maps are flat (but the Earth is round), the route of the shortest distance between 2 points on the Earth will often appear curved when viewed on a flat map, especially for long distances. If you were to simply draw a straight line on a flat map and measure a very long distance, it would likely be much further than if you were to lay a string between those two points on a globe. Because of the large distance between Guernsey Airport and Metlakatla Seaplane Base, the route shown on this map most likely appears curved because of this reason.

Try it at home! Get a globe and tightly lay a string between Guernsey Airport and Metlakatla Seaplane Base. You'll see that it will travel the same route of the red line on this map!

Departure Airport Information:

Arrival Airport Information:

Facts about Guernsey Airport (GCI):

• In 1960 there were four grass runways, with lengths ranging from 2,040 ft to 3,060 ft.
• A large number of single and twin-engined light and business aircraft are based at the airport.
• Because of Guernsey Airport's relatively low elevation of 336 feet, planes can take off or land at Guernsey Airport at a lower air speed than at airports located at a higher elevation. This is because the air density is higher closer to sea level than it would otherwise be at higher elevations.
• The closest airport to Guernsey Airport (GCI) is Jersey Airport (JER), which is located 24 miles (39 kilometers) SE of GCI.
• Guernsey Airport handled 886,396 passengers last year.
• The airport was officially opened on 5 May 1939.
• Guernsey Airport (GCI) currently has only 1 runway.
• The furthest airport from Guernsey Airport (GCI) is Dunedin International Airport (DUD), which is nearly antipodal to Guernsey Airport (meaning Guernsey Airport is almost on the exact opposite side of the Earth from Dunedin International Airport), and is located 12,024 miles (19,350 kilometers) away in Dunedin, Otago, New Zealand.
• Flybe are unable to operate their Embraer 195 aircraft into Guernsey due to the low strength of the runway, and elected to operate the smaller de Havilland Dash 8s.
• The proposal is to add runway safety areas, RESAs, extend the take-off section by 120 m, and displace the landing section to the west, the first of a two phase runway extension.

Facts about Metlakatla Seaplane Base (MTM):

• Metlakatla Seaplane Base has two seaplane landing areas designated E/W and N/S, each measuring 5,000 by 5,000 feet.
• The closest airport to Metlakatla Seaplane Base (MTM) is Annette Island Airport (ANN), which is located only 6 miles (10 kilometers) S of MTM.
• Metlakatla Seaplane Base (MTM) has 2 runways.
• Metlakatla Seaplane Base is a state owned, public use seaplane base located in Metlakatla, a community on Annette Island in the Prince of Wales-Hyder Census Area of the U.S.
• The furthest airport from Metlakatla Seaplane Base (MTM) is Port Alfred Airport (AFD), which is located 10,621 miles (17,093 kilometers) away in Port Alfred, South Africa.
• Because of Metlakatla Seaplane Base's relatively low elevation of 0 feet, planes can take off or land at Metlakatla Seaplane Base at a lower air speed than at airports located at a higher elevation. This is because the air density is higher closer to sea level than it would otherwise be at higher elevations.