Nonstop flight route between Grand Forks, North Dakota, United States and Bennettsville, South Carolina, United States:

About this route:

A direct, nonstop flight between Grand Forks International Airport (GFK), Grand Forks, North Dakota, United States and Marlboro County Jetport (BTN), Bennettsville, South Carolina, United States would travel a Great Circle distance of 1,286 miles (or 2,069 kilometers).

A Great Circle is the shortest distance between 2 points on a sphere. Because most world maps are flat (but the Earth is round), the route of the shortest distance between 2 points on the Earth will often appear curved when viewed on a flat map, especially for long distances. If you were to simply draw a straight line on a flat map and measure a very long distance, it would likely be much further than if you were to lay a string between those two points on a globe. Because of the relatively short distance between Grand Forks International Airport and Marlboro County Jetport, the route shown on this map most likely still appears to be a straight line.

Departure Airport Information:

Arrival Airport Information:

Facts about Grand Forks International Airport (GFK):

• In the mid-2000s, discussion began of upgrading or totally replacing the terminal as it has structural and safety problems and leaves little to no room for expansion.
• The new passenger terminal, designed by JLG Architects, is a two story building, with Delta and Allegiant ticketing counters, baggage claim carousel, and several rental car agencies.
• The consulting group recommended that a brand new passenger terminal would the best solution to the current terminal's problems.
• Grand Forks International Airport (GFK) has 4 runways.
• Because of Grand Forks International Airport's relatively low elevation of 845 feet, planes can take off or land at Grand Forks International Airport at a lower air speed than at airports located at a higher elevation. This is because the air density is higher closer to sea level than it would otherwise be at higher elevations.
• The furthest airport from Grand Forks International Airport (GFK) is Margaret River Airport (MGV), which is located 10,514 miles (16,921 kilometers) away in Margaret River, Western Australia, Australia.
• Due to the increased amount of general aviation traffic, primarily from the UND Aerospace flight training school, a fourth runway has been completed on the southeast side of the airport.
• The closest airport to Grand Forks International Airport (GFK) is Grand Forks Air Force Base (RDR), which is located only 10 miles (17 kilometers) W of GFK.
• On October 3, 2012, United Airlines started flights between Denver, CO and Grand Forks, but on September 10, 2013 they announced they would end service on December 3, 2013 citing low loads.

Facts about Marlboro County Jetport (BTN):

• Marlboro County Jetport (BTN) currently has only 1 runway.
• Because of Marlboro County Jetport's relatively low elevation of 147 feet, planes can take off or land at Marlboro County Jetport at a lower air speed than at airports located at a higher elevation. This is because the air density is higher closer to sea level than it would otherwise be at higher elevations.
• Marlboro County Jetport covers an area of 175 acres at an elevation of 147 feet above mean sea level.
• The closest airport to Marlboro County Jetport (BTN) is Cheraw Municipal Airport (HCW), which is located only 14 miles (23 kilometers) WNW of BTN.
• The furthest airport from Marlboro County Jetport (BTN) is Margaret River Airport (MGV), which is located 11,589 miles (18,651 kilometers) away in Margaret River, Western Australia, Australia.
• Inactivated on 16 October 1944 with the drawdown of AAFTC's pilot training program.
• In addition to being known as "Marlboro County Jetport", other names for BTN include "H.E. Avent Field" and "BBP".
• Opened on 8 October 1941.