Nonstop flight route between Sermiligaaq, Greenland and Bainbridge, Georgia, United States:

About this route:

A direct, nonstop flight between Sermiligaaq Heliport (SGG), Sermiligaaq, Greenland and Decatur County Industrial Air Park (BGE), Bainbridge, Georgia, United States would travel a Great Circle distance of 3,133 miles (or 5,042 kilometers).

A Great Circle is the shortest distance between 2 points on a sphere. Because most world maps are flat (but the Earth is round), the route of the shortest distance between 2 points on the Earth will often appear curved when viewed on a flat map, especially for long distances. If you were to simply draw a straight line on a flat map and measure a very long distance, it would likely be much further than if you were to lay a string between those two points on a globe. Because of the large distance between Sermiligaaq Heliport and Decatur County Industrial Air Park, the route shown on this map most likely appears curved because of this reason.

Try it at home! Get a globe and tightly lay a string between Sermiligaaq Heliport and Decatur County Industrial Air Park. You'll see that it will travel the same route of the red line on this map!

Departure Airport Information:

Arrival Airport Information:

Facts about Sermiligaaq Heliport (SGG):

• The closest airport to Sermiligaaq Heliport (SGG) is Kuummiit Heliport (KUZ), which is located only 18 miles (29 kilometers) W of SGG.
• Because of Sermiligaaq Heliport's relatively low elevation of 33 feet, planes can take off or land at Sermiligaaq Heliport at a lower air speed than at airports located at a higher elevation. This is because the air density is higher closer to sea level than it would otherwise be at higher elevations.
• The furthest airport from Sermiligaaq Heliport (SGG) is Ryan's Creek Aerodrome (SZS), which is located 10,847 miles (17,456 kilometers) away in Stewart Island, New Zealand.

Facts about Decatur County Industrial Air Park (BGE):

• Because of Decatur County Industrial Air Park's relatively low elevation of 141 feet, planes can take off or land at Decatur County Industrial Air Park at a lower air speed than at airports located at a higher elevation. This is because the air density is higher closer to sea level than it would otherwise be at higher elevations.
• The closest airport to Decatur County Industrial Air Park (BGE) is Tallahassee Regional Airport (TLH), which is located 43 miles (70 kilometers) SSE of BGE.
• The furthest airport from Decatur County Industrial Air Park (BGE) is Kalbarri Airport (KAX), which is located 11,278 miles (18,150 kilometers) away in Kalbarri, Western Australia, Australia.
• Following entry of the United States into World War II, the Chief of the Army Air Corps directed the Air Corps Flying Training Command Southeast Training Center to immediately take action to select air base sites needed to increase its pilot training rate to meet anticipated wartime demands.
• Decatur County Industrial Air Park (BGE) has 2 runways.
• During World War II, the airfield conducted flight training of new pilots by Army Air Forces Flying Training Command.