Nonstop flight route between Edmonton, Alberta, Canada and between Baltimore, Maryland and Washington, D.C., United States:

About this route:

A direct, nonstop flight between Edmonton International Airport (YEG), Edmonton, Alberta, Canada and Baltimore/Washington International Thurgood Marshall Airport (BWI), between Baltimore, Maryland and Washington, D.C., United States would travel a Great Circle distance of 1,985 miles (or 3,195 kilometers).

A Great Circle is the shortest distance between 2 points on a sphere. Because most world maps are flat (but the Earth is round), the route of the shortest distance between 2 points on the Earth will often appear curved when viewed on a flat map, especially for long distances. If you were to simply draw a straight line on a flat map and measure a very long distance, it would likely be much further than if you were to lay a string between those two points on a globe. Because of the relatively short distance between Edmonton International Airport and Baltimore/Washington International Thurgood Marshall Airport, the route shown on this map most likely still appears to be a straight line.

Departure Airport Information:

Arrival Airport Information:

Facts about Edmonton International Airport (YEG):

• The closest airport to Edmonton International Airport (YEG) is CFB Edmonton (YED), which is located 25 miles (41 kilometers) N of YEG.
• Edmonton International Airport handled 6,983,229 passengers last year.
• The furthest airport from Edmonton International Airport (YEG) is Tôlanaro Airport (FTU), which is located 10,239 miles (16,478 kilometers) away in Tôlanaro, Madagascar.
• An expansion program initiated in October 2007 is nearing completion.
• The Edmonton Area Control Centre operated by Nav Canada is located at the airport.
• EIA is located within the Edmonton Capital Region, close to the towns of Devon and Beaumont, the city of Leduc, and adjacent to the Nisku industrial park.
• During the 1970s, the airport experienced a rapid growth in traffic as the city of Edmonton grew, and served approximately 2 million passengers by 1980.
• Edmonton International Airport (YEG) has 2 runways.
• The SkyShuttle services the airport and selected stops in the city of Edmonton typically adjacent to major hotels.

Facts about Baltimore/Washington International Thurgood Marshall Airport (BWI):

• The closest airport to Baltimore/Washington International Thurgood Marshall Airport (BWI) is Tipton Airport (FME), which is located only 8 miles (13 kilometers) SW of BWI.
• Baltimore/Washington International Thurgood Marshall Airport handled 22,391,785 passengers last year.
• The furthest airport from Baltimore/Washington International Thurgood Marshall Airport (BWI) is Margaret River Airport (MGV), which is located 11,691 miles (18,814 kilometers) away in Margaret River, Western Australia, Australia.
• The Federal Aviation Administration is currently in the process of designing a new air traffic control tower that will replace the current tower.
• The first phase of BWI modernization was completed in 1974 at a cost of $30 million.
• Currently improvements are being made to widen concourse C.
• BWI is a focus city for Southwest Airlines, and is the busiest airport in the Baltimore–Washington Metropolitan Area.
• Baltimore/Washington International Thurgood Marshall Airport (BWI) has 4 runways.
• Baltimore/Washington International Thurgood Marshall Airport has five concourses, though Concourses A and B were essentially merged into a single concourse in the renovations completed in 2005.
• Passenger van service to and from the Eastern Shore and Western Maryland is available through BayRunner Shuttle with services to and from BWI to Kent Island, Easton, Cambridge, Salisbury, Ocean Pines, and Ocean City and Grantsville, Frostburg, Cumberland, Hancock, Hagerstown, and Frederick.
• Because of Baltimore/Washington International Thurgood Marshall Airport's relatively low elevation of 146 feet, planes can take off or land at Baltimore/Washington International Thurgood Marshall Airport at a lower air speed than at airports located at a higher elevation. This is because the air density is higher closer to sea level than it would otherwise be at higher elevations.