Nonstop flight route between Bainbridge, Georgia, United States and Greenville / Spartanburg, South Carolina, United States:

About this route:

A direct, nonstop flight between Decatur County Industrial Air Park (BGE), Bainbridge, Georgia, United States and Greenville–Spartanburg International Airport (GSP), Greenville / Spartanburg, South Carolina, United States would travel a Great Circle distance of 305 miles (or 491 kilometers).

A Great Circle is the shortest distance between 2 points on a sphere. Because most world maps are flat (but the Earth is round), the route of the shortest distance between 2 points on the Earth will often appear curved when viewed on a flat map, especially for long distances. If you were to simply draw a straight line on a flat map and measure a very long distance, it would likely be much further than if you were to lay a string between those two points on a globe. Because of the relatively short distance between Decatur County Industrial Air Park and Greenville–Spartanburg International Airport, the route shown on this map most likely still appears to be a straight line.

Departure Airport Information:

Arrival Airport Information:

Facts about Decatur County Industrial Air Park (BGE):

• The closest airport to Decatur County Industrial Air Park (BGE) is Tallahassee Regional Airport (TLH), which is located 43 miles (70 kilometers) SSE of BGE.
• Because of Decatur County Industrial Air Park's relatively low elevation of 141 feet, planes can take off or land at Decatur County Industrial Air Park at a lower air speed than at airports located at a higher elevation. This is because the air density is higher closer to sea level than it would otherwise be at higher elevations.
• The furthest airport from Decatur County Industrial Air Park (BGE) is Kalbarri Airport (KAX), which is located 11,278 miles (18,150 kilometers) away in Kalbarri, Western Australia, Australia.
• Following entry of the United States into World War II, the Chief of the Army Air Corps directed the Air Corps Flying Training Command Southeast Training Center to immediately take action to select air base sites needed to increase its pilot training rate to meet anticipated wartime demands.
• Decatur County Industrial Air Park (BGE) has 2 runways.
• There was little need, however, for the airfield, and in the immediate postwar years, farmers leased the open areas of the airfield for cultivation and the cantonment area was used for various purposes.
• As a result of the Korean War which began in 1950 and the expansion of the United States Air Force, Bainbridge Air Base* was reopened to train additional pilots.

Facts about Greenville–Spartanburg International Airport (GSP):

• In addition to being known as "Greenville–Spartanburg International Airport", another name for GSP is "Roger Milliken Field".
• The furthest airport from Greenville–Spartanburg International Airport (GSP) is Margaret River Airport (MGV), which is located 11,449 miles (18,425 kilometers) away in Margaret River, Western Australia, Australia.
• Because of Greenville–Spartanburg International Airport's relatively low elevation of 964 feet, planes can take off or land at Greenville–Spartanburg International Airport at a lower air speed than at airports located at a higher elevation. This is because the air density is higher closer to sea level than it would otherwise be at higher elevations.
• Greenville–Spartanburg International Airport (GSP) currently has only 1 runway.
• The closest airport to Greenville–Spartanburg International Airport (GSP) is Greenville Downtown Airport (GMU), which is located only 8 miles (13 kilometers) WSW of GSP.
• Prior to GSP, Greenville and Spartanburg had separate airports and competed for airline service.
• Local officials attribute Southwest's presence to an unprecedented 38 percent growth in passenger figures between 2010 and 2011.
• Greenville–Spartanburg International Airport handled 1,856,316 passengers last year.
• The airport can handle up to 250 passengers per hour through immigration and customs checkpoints.