Nonstop flight route between Bellingham, Washington, United States and Bainbridge, Georgia, United States:

About this route:

A direct, nonstop flight between Bellingham International Airport (BLI), Bellingham, Washington, United States and Decatur County Industrial Air Park (BGE), Bainbridge, Georgia, United States would travel a Great Circle distance of 2,322 miles (or 3,737 kilometers).

A Great Circle is the shortest distance between 2 points on a sphere. Because most world maps are flat (but the Earth is round), the route of the shortest distance between 2 points on the Earth will often appear curved when viewed on a flat map, especially for long distances. If you were to simply draw a straight line on a flat map and measure a very long distance, it would likely be much further than if you were to lay a string between those two points on a globe. Because of the relatively short distance between Bellingham International Airport and Decatur County Industrial Air Park, the route shown on this map most likely still appears to be a straight line.

Departure Airport Information:

Arrival Airport Information:

Facts about Bellingham International Airport (BLI):

• In addition to being known as "Bellingham International Airport", another name for BLI is "(Bellingham/Tulip Army Airfield)".
• Because of Bellingham International Airport's relatively low elevation of 170 feet, planes can take off or land at Bellingham International Airport at a lower air speed than at airports located at a higher elevation. This is because the air density is higher closer to sea level than it would otherwise be at higher elevations.
• In early 2007 Bellingham International hosted service to three destinations by the short-lived Western Airlines.
• Bellingham International Airport has bustling general aviation activity, most of which is for the purpose of sightseeing in the San Juan Islands, Victoria in British Columbia, or the Canadian Gulf Islands.
• Bellingham International Airport (BLI) currently has only 1 runway.
• In 1940 the United States Army Corps of Engineers took over the facility and expanded it to three full runways, revetments for parking aircraft, and development of personnel quarters.
• The closest airport to Bellingham International Airport (BLI) is Blaine Municipal Airport (BWS), which is located only 16 miles (26 kilometers) NNW of BLI.
• The furthest airport from Bellingham International Airport (BLI) is Tôlanaro Airport (FTU), which is located 10,700 miles (17,220 kilometers) away in Tôlanaro, Madagascar.

Facts about Decatur County Industrial Air Park (BGE):

• Decatur County Industrial Air Park (BGE) has 2 runways.
• During World War II, the airfield conducted flight training of new pilots by Army Air Forces Flying Training Command.
• Following entry of the United States into World War II, the Chief of the Army Air Corps directed the Air Corps Flying Training Command Southeast Training Center to immediately take action to select air base sites needed to increase its pilot training rate to meet anticipated wartime demands.
• Because of Decatur County Industrial Air Park's relatively low elevation of 141 feet, planes can take off or land at Decatur County Industrial Air Park at a lower air speed than at airports located at a higher elevation. This is because the air density is higher closer to sea level than it would otherwise be at higher elevations.
• The closest airport to Decatur County Industrial Air Park (BGE) is Tallahassee Regional Airport (TLH), which is located 43 miles (70 kilometers) SSE of BGE.
• The furthest airport from Decatur County Industrial Air Park (BGE) is Kalbarri Airport (KAX), which is located 11,278 miles (18,150 kilometers) away in Kalbarri, Western Australia, Australia.