Nonstop flight route between Bettles, Alaska, United States and Bainbridge, Georgia, United States:

About this route:

A direct, nonstop flight between Bettles Airport (BTT), Bettles, Alaska, United States and Decatur County Industrial Air Park (BGE), Bainbridge, Georgia, United States would travel a Great Circle distance of 3,644 miles (or 5,865 kilometers).

A Great Circle is the shortest distance between 2 points on a sphere. Because most world maps are flat (but the Earth is round), the route of the shortest distance between 2 points on the Earth will often appear curved when viewed on a flat map, especially for long distances. If you were to simply draw a straight line on a flat map and measure a very long distance, it would likely be much further than if you were to lay a string between those two points on a globe. Because of the large distance between Bettles Airport and Decatur County Industrial Air Park, the route shown on this map most likely appears curved because of this reason.

Try it at home! Get a globe and tightly lay a string between Bettles Airport and Decatur County Industrial Air Park. You'll see that it will travel the same route of the red line on this map!

Departure Airport Information:

Arrival Airport Information:

Facts about Bettles Airport (BTT):

• The closest airport to Bettles Airport (BTT) is Prospect Creek Airport (PPC), which is located 25 miles (40 kilometers) ESE of BTT.
• Bettles Airport (BTT) has 3 runways.
• The furthest airport from Bettles Airport (BTT) is Port Elizabeth International Airport (PLZ), which is located 10,159 miles (16,349 kilometers) away in Port Elizabeth, South Africa.
• Because of Bettles Airport's relatively low elevation of 647 feet, planes can take off or land at Bettles Airport at a lower air speed than at airports located at a higher elevation. This is because the air density is higher closer to sea level than it would otherwise be at higher elevations.
• Bettles Airport covers 1,195 acres 1,195 acres which contains one runway designated 1/19 with a 5,190 x 150 ft gravel surface.

Facts about Decatur County Industrial Air Park (BGE):

• The contractor broke ground on 3 April 1942, for Bainbridge Army Airfield.
• Decatur County Industrial Air Park (BGE) has 2 runways.
• There was little need, however, for the airfield, and in the immediate postwar years, farmers leased the open areas of the airfield for cultivation and the cantonment area was used for various purposes.
• The furthest airport from Decatur County Industrial Air Park (BGE) is Kalbarri Airport (KAX), which is located 11,278 miles (18,150 kilometers) away in Kalbarri, Western Australia, Australia.
• The closest airport to Decatur County Industrial Air Park (BGE) is Tallahassee Regional Airport (TLH), which is located 43 miles (70 kilometers) SSE of BGE.
• Following entry of the United States into World War II, the Chief of the Army Air Corps directed the Air Corps Flying Training Command Southeast Training Center to immediately take action to select air base sites needed to increase its pilot training rate to meet anticipated wartime demands.
• Because of Decatur County Industrial Air Park's relatively low elevation of 141 feet, planes can take off or land at Decatur County Industrial Air Park at a lower air speed than at airports located at a higher elevation. This is because the air density is higher closer to sea level than it would otherwise be at higher elevations.