Nonstop flight route between Fort Wayne, Indiana, United States and Bainbridge, Georgia, United States:
Departure Airport:
Arrival Airport:
Distance from FWA to BGE:
Share this route:
Jump to:
- About this route
- FWA Airport Information
- BGE Airport Information
- Facts about FWA
- Facts about BGE
- Map of Nearest Airports to FWA
- List of Nearest Airports to FWA
- Map of Furthest Airports from FWA
- List of Furthest Airports from FWA
- Map of Nearest Airports to BGE
- List of Nearest Airports to BGE
- Map of Furthest Airports from BGE
- List of Furthest Airports from BGE
About this route:
A direct, nonstop flight between Fort Wayne International Airport (FWA), Fort Wayne, Indiana, United States and Decatur County Industrial Air Park (BGE), Bainbridge, Georgia, United States would travel a Great Circle distance of 692 miles (or 1,114 kilometers).
A Great Circle is the shortest distance between 2 points on a sphere. Because most world maps are flat (but the Earth is round), the route of the shortest distance between 2 points on the Earth will often appear curved when viewed on a flat map, especially for long distances. If you were to simply draw a straight line on a flat map and measure a very long distance, it would likely be much further than if you were to lay a string between those two points on a globe. Because of the relatively short distance between Fort Wayne International Airport and Decatur County Industrial Air Park, the route shown on this map most likely still appears to be a straight line.
Departure Airport Information:
| IATA / ICAO Codes: | FWA / KFWA |
| Airport Name: | Fort Wayne International Airport |
| Location: | Fort Wayne, Indiana, United States |
| GPS Coordinates: | 40°58'41"N by 85°11'43"W |
| Area Served: | Fort Wayne, Indiana |
| Airport Type: | Public |
| Elevation: | 814 feet (248 meters) |
| # of Runways: | 3 |
| View all routes: | Routes from FWA |
| More Information: | FWA Maps & Info |
Arrival Airport Information:
| IATA / ICAO Codes: | BGE / KBGE |
| Airport Name: | Decatur County Industrial Air Park |
| Location: | Bainbridge, Georgia, United States |
| GPS Coordinates: | 30°58'18"N by 84°38'15"W |
| Area Served: | Decatur County |
| Operator/Owner: | Decatur County |
| Airport Type: | Public |
| Elevation: | 141 feet (43 meters) |
| # of Runways: | 2 |
| View all routes: | Routes from BGE |
| More Information: | BGE Maps & Info |
Facts about Fort Wayne International Airport (FWA):
- The airport now has limited concessions post-security, as the current setup is a temporary improvement over the pre-2011 layout.
- The closest airport to Fort Wayne International Airport (FWA) is Smith Field (SMD), which is located only 12 miles (19 kilometers) N of FWA.
- In addition to Delta, United, and later American, locally-based Hub Airlines and other regional airlines flew to the airport in the 1960s and 1970s.
- Because of Fort Wayne International Airport's relatively low elevation of 814 feet, planes can take off or land at Fort Wayne International Airport at a lower air speed than at airports located at a higher elevation. This is because the air density is higher closer to sea level than it would otherwise be at higher elevations.
- Fort Wayne International Airport (FWA) has 3 runways.
- The airport has one terminal, the Lieutenant Paul Baer Terminal.
- The furthest airport from Fort Wayne International Airport (FWA) is Margaret River Airport (MGV), which is located 11,226 miles (18,066 kilometers) away in Margaret River, Western Australia, Australia.
Facts about Decatur County Industrial Air Park (BGE):
- Following entry of the United States into World War II, the Chief of the Army Air Corps directed the Air Corps Flying Training Command Southeast Training Center to immediately take action to select air base sites needed to increase its pilot training rate to meet anticipated wartime demands.
- The furthest airport from Decatur County Industrial Air Park (BGE) is Kalbarri Airport (KAX), which is located 11,278 miles (18,150 kilometers) away in Kalbarri, Western Australia, Australia.
- Because of Decatur County Industrial Air Park's relatively low elevation of 141 feet, planes can take off or land at Decatur County Industrial Air Park at a lower air speed than at airports located at a higher elevation. This is because the air density is higher closer to sea level than it would otherwise be at higher elevations.
- Today, Bainbridge is used for various purposes in addition to a small amount of aviation activity.
- Decatur County Industrial Air Park (BGE) has 2 runways.
- Decatur County Industrial Air Park Airport covers an area of 940 acres at an elevation of 141 feet above mean sea level.
- The closest airport to Decatur County Industrial Air Park (BGE) is Tallahassee Regional Airport (TLH), which is located 43 miles (70 kilometers) SSE of BGE.
