Nonstop flight route between Gympie, Queensland, Australia and Bainbridge, Georgia, United States:

About this route:

A direct, nonstop flight between Gympie Airport (GYP), Gympie, Queensland, Australia and Decatur County Industrial Air Park (BGE), Bainbridge, Georgia, United States would travel a Great Circle distance of 8,982 miles (or 14,455 kilometers).

A Great Circle is the shortest distance between 2 points on a sphere. Because most world maps are flat (but the Earth is round), the route of the shortest distance between 2 points on the Earth will often appear curved when viewed on a flat map, especially for long distances. If you were to simply draw a straight line on a flat map and measure a very long distance, it would likely be much further than if you were to lay a string between those two points on a globe. Because of the large distance between Gympie Airport and Decatur County Industrial Air Park, the route shown on this map most likely appears curved because of this reason.

Try it at home! Get a globe and tightly lay a string between Gympie Airport and Decatur County Industrial Air Park. You'll see that it will travel the same route of the red line on this map!

Departure Airport Information:

Arrival Airport Information:

Facts about Gympie Airport (GYP):

• The furthest airport from Gympie Airport (GYP) is La Palma Airport (SPC), which is located 11,830 miles (19,038 kilometers) away in La Palma, Canary Islands, Spain.
• The closest airport to Gympie Airport (GYP) is Sunshine-Coast-Airport (MCY), which is located 33 miles (53 kilometers) SE of GYP.
• Because of Gympie Airport's relatively low elevation of 260 feet, planes can take off or land at Gympie Airport at a lower air speed than at airports located at a higher elevation. This is because the air density is higher closer to sea level than it would otherwise be at higher elevations.
• Gympie Airport (GYP) has 2 runways.

Facts about Decatur County Industrial Air Park (BGE):

• The furthest airport from Decatur County Industrial Air Park (BGE) is Kalbarri Airport (KAX), which is located 11,278 miles (18,150 kilometers) away in Kalbarri, Western Australia, Australia.
• Decatur County Industrial Air Park Airport covers an area of 940 acres at an elevation of 141 feet above mean sea level.
• Decatur County Industrial Air Park (BGE) has 2 runways.
• Because of Decatur County Industrial Air Park's relatively low elevation of 141 feet, planes can take off or land at Decatur County Industrial Air Park at a lower air speed than at airports located at a higher elevation. This is because the air density is higher closer to sea level than it would otherwise be at higher elevations.
• The closest airport to Decatur County Industrial Air Park (BGE) is Tallahassee Regional Airport (TLH), which is located 43 miles (70 kilometers) SSE of BGE.
• The contractor broke ground on 3 April 1942, for Bainbridge Army Airfield.
• Following entry of the United States into World War II, the Chief of the Army Air Corps directed the Air Corps Flying Training Command Southeast Training Center to immediately take action to select air base sites needed to increase its pilot training rate to meet anticipated wartime demands.