Nonstop flight route between Bullhead City, Arizona, United States and Shellharbour, Wollongong, New South Wales, Australia:

About this route:

A direct, nonstop flight between Laughlin/Bullhead International Airport (IFP), Bullhead City, Arizona, United States and Illawarra Regional Airport (WOL), Shellharbour, Wollongong, New South Wales, Australia would travel a Great Circle distance of 7,767 miles (or 12,500 kilometers).

A Great Circle is the shortest distance between 2 points on a sphere. Because most world maps are flat (but the Earth is round), the route of the shortest distance between 2 points on the Earth will often appear curved when viewed on a flat map, especially for long distances. If you were to simply draw a straight line on a flat map and measure a very long distance, it would likely be much further than if you were to lay a string between those two points on a globe. Because of the large distance between Laughlin/Bullhead International Airport and Illawarra Regional Airport, the route shown on this map most likely appears curved because of this reason.

Try it at home! Get a globe and tightly lay a string between Laughlin/Bullhead International Airport and Illawarra Regional Airport. You'll see that it will travel the same route of the red line on this map!

Departure Airport Information:

Arrival Airport Information:

Facts about Laughlin/Bullhead International Airport (IFP):

• In 2002 Sun Country decided to start service to Bullhead City from Minneapolis.
• The furthest airport from Laughlin/Bullhead International Airport (IFP) is Sir Gaëtan Duval Airport (RRG), which is located 11,365 miles (18,291 kilometers) away in Rodrigues Island, Mauritius.
• Laughlin/Bullhead International Airport (IFP) currently has only 1 runway.
• On April 9–10, 2011, Laughlin/Bullhead International Airport held the second annual "Legends Over The Colorado".
• IFP has three instrument approaches.
• Because of Laughlin/Bullhead International Airport's relatively low elevation of 701 feet, planes can take off or land at Laughlin/Bullhead International Airport at a lower air speed than at airports located at a higher elevation. This is because the air density is higher closer to sea level than it would otherwise be at higher elevations.
• On July 20, 2011 marked the opening of the new baggage claim building connected to the main terminal.
• The closest airport to Laughlin/Bullhead International Airport (IFP) is Needles AirportNeedles Army Airfield (EED), which is located 27 miles (44 kilometers) S of IFP.
• The FAA requires there to be 1,000 feet reserved for the Runway Safety Area at each end of a runway.

Facts about Illawarra Regional Airport (WOL):

• Because of Illawarra Regional Airport's relatively low elevation of 31 feet, planes can take off or land at Illawarra Regional Airport at a lower air speed than at airports located at a higher elevation. This is because the air density is higher closer to sea level than it would otherwise be at higher elevations.
• The Historical Aircraft Restoration Society is based at Illawarra Regional Airport.
• The closest airport to Illawarra Regional Airport (WOL) is Camden Aerodrome (CDU), which is located 36 miles (59 kilometers) N of WOL.
• In addition to being known as "Illawarra Regional Airport", another name for WOL is "Wollongong Airport".
• Illawarra Regional Airport (WOL) has 2 runways.
• The furthest airport from Illawarra Regional Airport (WOL) is Horta International Airport (HOR), which is nearly antipodal to Illawarra Regional Airport (meaning Illawarra Regional Airport is almost on the exact opposite side of the Earth from Horta International Airport), and is located 12,162 miles (19,573 kilometers) away in Horta, Azores, Portugal.
• The Illawarra Regional Airport provides a cost effective alternative to the Sydney Basin airports for light aircraft users.
• There is no control tower located at the airport and pilots must co-ordinate arrivals and departures using a Common Traffic Advisory Frequency, aided by an Aerodrome Frequency Response Unit, which notifies pilots that their transmissions have been received on the frequency and activates lighting systems as appropriate.