Nonstop flight route between Edmonton, Alberta, Canada and Dillon, South Carolina, United States:
Departure Airport:

Arrival Airport:

Distance from YED to DLL:
Share this route:
Jump to:
- About this route
- YED Airport Information
- DLL Airport Information
- Facts about YED
- Facts about DLL
- Map of Nearest Airports to YED
- List of Nearest Airports to YED
- Map of Furthest Airports from YED
- List of Furthest Airports from YED
- Map of Nearest Airports to DLL
- List of Nearest Airports to DLL
- Map of Furthest Airports from DLL
- List of Furthest Airports from DLL
About this route:
A direct, nonstop flight between CFB Edmonton (YED), Edmonton, Alberta, Canada and Dillon County Airport (DLL), Dillon, South Carolina, United States would travel a Great Circle distance of 2,119 miles (or 3,410 kilometers).
A Great Circle is the shortest distance between 2 points on a sphere. Because most world maps are flat (but the Earth is round), the route of the shortest distance between 2 points on the Earth will often appear curved when viewed on a flat map, especially for long distances. If you were to simply draw a straight line on a flat map and measure a very long distance, it would likely be much further than if you were to lay a string between those two points on a globe. Because of the relatively short distance between CFB Edmonton and Dillon County Airport, the route shown on this map most likely still appears to be a straight line.
Departure Airport Information:
IATA / ICAO Codes: | YED / CYED |
Airport Names: |
|
Location: | Edmonton, Alberta, Canada |
GPS Coordinates: | 53°40'27"N by 113°29'29"W |
Operator/Owner: | Government of Canada |
Airport Type: | Military |
Elevation: | 2257 feet (688 meters) |
View all routes: | Routes from YED |
More Information: | YED Maps & Info |
Arrival Airport Information:
IATA / ICAO Codes: | DLL / KDLC |
Airport Names: |
|
Location: | Dillon, South Carolina, United States |
GPS Coordinates: | 34°26'57"N by 79°22'6"W |
Area Served: | Dillon, South Carolina |
Operator/Owner: | Dillon County |
Airport Type: | Public |
Elevation: | 133 feet (41 meters) |
# of Runways: | 1 |
View all routes: | Routes from DLL |
More Information: | DLL Maps & Info |
Facts about CFB Edmonton (YED):
- In February 2012, it was reported that the Alberta Government had been in contact with the federal government and military officials in Ottawa and Edmonton over the use of the runway for MEDIVAC flights once Edmonton City Centre is closed.
- The closest airport to CFB Edmonton (YED) is Edmonton International Airport (YEG), which is located 25 miles (41 kilometers) S of YED.
- The furthest airport from CFB Edmonton (YED) is Tôlanaro Airport (FTU), which is located 10,216 miles (16,441 kilometers) away in Tôlanaro, Madagascar.
- With the formation of air force wings in the 1990s the base became 18 Wing.
- The history of CFB Edmonton begins at an old airfield called Blatchford Field, a few kilometres south from where CFB Edmonton would eventually be established.
- The Area Support Unit and CFB Edmonton provide infrastructure and support to 47 units located in and around Edmonton.
- In addition to being known as "CFB Edmonton", other names for YED include "Edmonton/Namao Heliport Edmonton Garrison" and "Steele Barracks".
Facts about Dillon County Airport (DLL):
- Dillon County Airport (DLL) currently has only 1 runway.
- Because of Dillon County Airport's relatively low elevation of 133 feet, planes can take off or land at Dillon County Airport at a lower air speed than at airports located at a higher elevation. This is because the air density is higher closer to sea level than it would otherwise be at higher elevations.
- The furthest airport from Dillon County Airport (DLL) is Margaret River Airport (MGV), which is located 11,610 miles (18,684 kilometers) away in Margaret River, Western Australia, Australia.
- The closest airport to Dillon County Airport (DLL) is Lumberton Municipal Airport (LBT), which is located 21 miles (33 kilometers) ENE of DLL.
- In addition to being known as "Dillon County Airport", another name for DLL is "DLC".