Nonstop flight route between Waco, Texas, United States and Bainbridge, Georgia, United States:

About this route:

A direct, nonstop flight between Waco Regional Airport (ACT), Waco, Texas, United States and Decatur County Industrial Air Park (BGE), Bainbridge, Georgia, United States would travel a Great Circle distance of 744 miles (or 1,198 kilometers).

A Great Circle is the shortest distance between 2 points on a sphere. Because most world maps are flat (but the Earth is round), the route of the shortest distance between 2 points on the Earth will often appear curved when viewed on a flat map, especially for long distances. If you were to simply draw a straight line on a flat map and measure a very long distance, it would likely be much further than if you were to lay a string between those two points on a globe. Because of the relatively short distance between Waco Regional Airport and Decatur County Industrial Air Park, the route shown on this map most likely still appears to be a straight line.

Departure Airport Information:

Arrival Airport Information:

Facts about Waco Regional Airport (ACT):

• Because of Waco Regional Airport's relatively low elevation of 516 feet, planes can take off or land at Waco Regional Airport at a lower air speed than at airports located at a higher elevation. This is because the air density is higher closer to sea level than it would otherwise be at higher elevations.
• The furthest airport from Waco Regional Airport (ACT) is Sir Gaëtan Duval Airport (RRG), which is located 10,981 miles (17,672 kilometers) away in Rodrigues Island, Mauritius.
• Waco Regional Airport (ACT) has 2 runways.
• In addition to being known as "Waco Regional Airport", another name for ACT is "Blackland AAF".
• It was first a glider training school and in October 1942 Blackland was assigned to the AAF Gulf Coast Training Center, with the Army Air Force Pilot School activated.
• Waco Regional Airport is five miles northwest of Waco, in McLennan County, Texas.
• The closest airport to Waco Regional Airport (ACT) is TSTC Waco Airport (CNW), which is located only 9 miles (15 kilometers) ENE of ACT.

Facts about Decatur County Industrial Air Park (BGE):

• The contractor broke ground on 3 April 1942, for Bainbridge Army Airfield.
• Following entry of the United States into World War II, the Chief of the Army Air Corps directed the Air Corps Flying Training Command Southeast Training Center to immediately take action to select air base sites needed to increase its pilot training rate to meet anticipated wartime demands.
• Because of Decatur County Industrial Air Park's relatively low elevation of 141 feet, planes can take off or land at Decatur County Industrial Air Park at a lower air speed than at airports located at a higher elevation. This is because the air density is higher closer to sea level than it would otherwise be at higher elevations.
• There was little need, however, for the airfield, and in the immediate postwar years, farmers leased the open areas of the airfield for cultivation and the cantonment area was used for various purposes.
• Decatur County Industrial Air Park (BGE) has 2 runways.
• The closest airport to Decatur County Industrial Air Park (BGE) is Tallahassee Regional Airport (TLH), which is located 43 miles (70 kilometers) SSE of BGE.
• The furthest airport from Decatur County Industrial Air Park (BGE) is Kalbarri Airport (KAX), which is located 11,278 miles (18,150 kilometers) away in Kalbarri, Western Australia, Australia.