Nonstop flight route between Bainbridge, Georgia, United States and Grand Rapids, Michigan, United States:

About this route:

A direct, nonstop flight between Decatur County Industrial Air Park (BGE), Bainbridge, Georgia, United States and Gerald R. Ford International Airport (GRR), Grand Rapids, Michigan, United States would travel a Great Circle distance of 824 miles (or 1,327 kilometers).

A Great Circle is the shortest distance between 2 points on a sphere. Because most world maps are flat (but the Earth is round), the route of the shortest distance between 2 points on the Earth will often appear curved when viewed on a flat map, especially for long distances. If you were to simply draw a straight line on a flat map and measure a very long distance, it would likely be much further than if you were to lay a string between those two points on a globe. Because of the relatively short distance between Decatur County Industrial Air Park and Gerald R. Ford International Airport, the route shown on this map most likely still appears to be a straight line.

Departure Airport Information:

Arrival Airport Information:

Facts about Decatur County Industrial Air Park (BGE):

• Because of Decatur County Industrial Air Park's relatively low elevation of 141 feet, planes can take off or land at Decatur County Industrial Air Park at a lower air speed than at airports located at a higher elevation. This is because the air density is higher closer to sea level than it would otherwise be at higher elevations.
• The closest airport to Decatur County Industrial Air Park (BGE) is Tallahassee Regional Airport (TLH), which is located 43 miles (70 kilometers) SSE of BGE.
• Following entry of the United States into World War II, the Chief of the Army Air Corps directed the Air Corps Flying Training Command Southeast Training Center to immediately take action to select air base sites needed to increase its pilot training rate to meet anticipated wartime demands.
• As a result of the Korean War which began in 1950 and the expansion of the United States Air Force, Bainbridge Air Base* was reopened to train additional pilots.
• Decatur County Industrial Air Park (BGE) has 2 runways.
• A level area near Bainbridge, seven miles northwest of the City adjacent to the Seaboard Air Line Railroad was selected by the Air Corps, and the City of Bainbridge and Decatur County purchased 2,070 acres for $66,800 and then leased the property to the Army for $1 per annum for a basic flight training base authorizing 89.9 million for its construction.
• The furthest airport from Decatur County Industrial Air Park (BGE) is Kalbarri Airport (KAX), which is located 11,278 miles (18,150 kilometers) away in Kalbarri, Western Australia, Australia.

Facts about Gerald R. Ford International Airport (GRR):

• When new baggage screening regulations were introduced by the Transportation Security Administration in 2002, the airport was one of the first in the nation to conduct trials on the new screening machines.
• The furthest airport from Gerald R. Ford International Airport (GRR) is Margaret River Airport (MGV), which is located 11,165 miles (17,969 kilometers) away in Margaret River, Western Australia, Australia.
• The closest airport to Gerald R. Ford International Airport (GRR) is Park Township Airport (HLM), which is located 33 miles (53 kilometers) W of GRR.
• 81,221,489 pounds of air freight were handled in 2012, representing an increase of 0.6% over the previous year.
• Gerald R. Ford International Airport (GRR) has 3 runways.
• The first scheduled air service in the United States was between Grand Rapids and Detroit on a Ford-Stout monoplane named Miss Grand Rapids, which started July 26, 1926.
• Because of Gerald R. Ford International Airport's relatively low elevation of 794 feet, planes can take off or land at Gerald R. Ford International Airport at a lower air speed than at airports located at a higher elevation. This is because the air density is higher closer to sea level than it would otherwise be at higher elevations.
• The airport has two aircraft spotter locations.
• In 1997 the new 8,500-foot runway 17/35 was added to allow the airport to continue operations during the $32 million reconstruction of runway 8R/26L, completed in 2001.