Nonstop flight route between Bloomington, Indiana, United States and Bainbridge, Georgia, United States:

About this route:

A direct, nonstop flight between Monroe County Airport (BMG), Bloomington, Indiana, United States and Decatur County Industrial Air Park (BGE), Bainbridge, Georgia, United States would travel a Great Circle distance of 576 miles (or 927 kilometers).

A Great Circle is the shortest distance between 2 points on a sphere. Because most world maps are flat (but the Earth is round), the route of the shortest distance between 2 points on the Earth will often appear curved when viewed on a flat map, especially for long distances. If you were to simply draw a straight line on a flat map and measure a very long distance, it would likely be much further than if you were to lay a string between those two points on a globe. Because of the relatively short distance between Monroe County Airport and Decatur County Industrial Air Park, the route shown on this map most likely still appears to be a straight line.

Departure Airport Information:

Arrival Airport Information:

Facts about Monroe County Airport (BMG):

• The furthest airport from Monroe County Airport (BMG) is Margaret River Airport (MGV), which is located 11,182 miles (17,996 kilometers) away in Margaret River, Western Australia, Australia.
• The closest airport to Monroe County Airport (BMG) is Virgil I. Grissom Municipal Airport (BFR), which is located 23 miles (37 kilometers) SSE of BMG.
• Monroe County Airport (BMG) has 2 runways.
• Monroe County Airport covers an area of 1,035 acres at an elevation of 845 feet above mean sea level.
• Because of Monroe County Airport's relatively low elevation of 846 feet, planes can take off or land at Monroe County Airport at a lower air speed than at airports located at a higher elevation. This is because the air density is higher closer to sea level than it would otherwise be at higher elevations.

Facts about Decatur County Industrial Air Park (BGE):

• During World War II, the airfield conducted flight training of new pilots by Army Air Forces Flying Training Command.
• The closest airport to Decatur County Industrial Air Park (BGE) is Tallahassee Regional Airport (TLH), which is located 43 miles (70 kilometers) SSE of BGE.
• Decatur County Industrial Air Park (BGE) has 2 runways.
• The furthest airport from Decatur County Industrial Air Park (BGE) is Kalbarri Airport (KAX), which is located 11,278 miles (18,150 kilometers) away in Kalbarri, Western Australia, Australia.
• Because of Decatur County Industrial Air Park's relatively low elevation of 141 feet, planes can take off or land at Decatur County Industrial Air Park at a lower air speed than at airports located at a higher elevation. This is because the air density is higher closer to sea level than it would otherwise be at higher elevations.
• Decatur County Industrial Air Park Airport covers an area of 940 acres at an elevation of 141 feet above mean sea level.
• A level area near Bainbridge, seven miles northwest of the City adjacent to the Seaboard Air Line Railroad was selected by the Air Corps, and the City of Bainbridge and Decatur County purchased 2,070 acres for $66,800 and then leased the property to the Army for $1 per annum for a basic flight training base authorizing 89.9 million for its construction.
• Following entry of the United States into World War II, the Chief of the Army Air Corps directed the Air Corps Flying Training Command Southeast Training Center to immediately take action to select air base sites needed to increase its pilot training rate to meet anticipated wartime demands.
• There was little need, however, for the airfield, and in the immediate postwar years, farmers leased the open areas of the airfield for cultivation and the cantonment area was used for various purposes.