Nonstop flight route between Keene, New Hampshire, United States and Bainbridge, Georgia, United States:

About this route:

A direct, nonstop flight between Dillant–Hopkins Airport (EEN), Keene, New Hampshire, United States and Decatur County Industrial Air Park (BGE), Bainbridge, Georgia, United States would travel a Great Circle distance of 1,068 miles (or 1,719 kilometers).

A Great Circle is the shortest distance between 2 points on a sphere. Because most world maps are flat (but the Earth is round), the route of the shortest distance between 2 points on the Earth will often appear curved when viewed on a flat map, especially for long distances. If you were to simply draw a straight line on a flat map and measure a very long distance, it would likely be much further than if you were to lay a string between those two points on a globe. Because of the relatively short distance between Dillant–Hopkins Airport and Decatur County Industrial Air Park, the route shown on this map most likely still appears to be a straight line.

Departure Airport Information:

Arrival Airport Information:

Facts about Dillant–Hopkins Airport (EEN):

• 1954 would see Northeast Airlines begin its air freight service out of the airport, six years after air freight service first began there.
• In May 1961 Mohawk ceased servicing Keene using the DC3 and switched to the Convair 440 for its passenger service into the city.
• The closest airport to Dillant–Hopkins Airport (EEN) is Jaffrey Airport - Silver Ranch Airpark (AFN), which is located only 15 miles (24 kilometers) ESE of EEN.
• Because of Dillant–Hopkins Airport's relatively low elevation of 149 feet, planes can take off or land at Dillant–Hopkins Airport at a lower air speed than at airports located at a higher elevation. This is because the air density is higher closer to sea level than it would otherwise be at higher elevations.
• In 1967 the FAA recommended a $1.8 million series of improvements which would include further extending the runways, the construction of a control tower, improved buildings, and other facilities.
• Dillant–Hopkins Airport (EEN) has 2 runways.
• In 1953 Dillant–Hopkins hosted an air show which brought flying teams from the US Air Force and US Navy to Keene.
• The furthest airport from Dillant–Hopkins Airport (EEN) is Margaret River Airport (MGV), which is located 11,700 miles (18,830 kilometers) away in Margaret River, Western Australia, Australia.

Facts about Decatur County Industrial Air Park (BGE):

• During World War II, the airfield conducted flight training of new pilots by Army Air Forces Flying Training Command.
• The furthest airport from Decatur County Industrial Air Park (BGE) is Kalbarri Airport (KAX), which is located 11,278 miles (18,150 kilometers) away in Kalbarri, Western Australia, Australia.
• Following entry of the United States into World War II, the Chief of the Army Air Corps directed the Air Corps Flying Training Command Southeast Training Center to immediately take action to select air base sites needed to increase its pilot training rate to meet anticipated wartime demands.
• Through the years a lot of material has been gathered about the Southern Airways School and Bainbridge Air Base.
• The closest airport to Decatur County Industrial Air Park (BGE) is Tallahassee Regional Airport (TLH), which is located 43 miles (70 kilometers) SSE of BGE.
• Decatur County Industrial Air Park (BGE) has 2 runways.
• Because of Decatur County Industrial Air Park's relatively low elevation of 141 feet, planes can take off or land at Decatur County Industrial Air Park at a lower air speed than at airports located at a higher elevation. This is because the air density is higher closer to sea level than it would otherwise be at higher elevations.