Nonstop flight route between Grand Forks, North Dakota, United States and Bainbridge, Georgia, United States:

About this route:

A direct, nonstop flight between Grand Forks International Airport (GFK), Grand Forks, North Dakota, United States and Decatur County Industrial Air Park (BGE), Bainbridge, Georgia, United States would travel a Great Circle distance of 1,346 miles (or 2,167 kilometers).

A Great Circle is the shortest distance between 2 points on a sphere. Because most world maps are flat (but the Earth is round), the route of the shortest distance between 2 points on the Earth will often appear curved when viewed on a flat map, especially for long distances. If you were to simply draw a straight line on a flat map and measure a very long distance, it would likely be much further than if you were to lay a string between those two points on a globe. Because of the relatively short distance between Grand Forks International Airport and Decatur County Industrial Air Park, the route shown on this map most likely still appears to be a straight line.

Departure Airport Information:

Arrival Airport Information:

Facts about Grand Forks International Airport (GFK):

• Grand Forks International Airport (GFK) has 4 runways.
• The new passenger terminal, designed by JLG Architects, is a two story building, with Delta and Allegiant ticketing counters, baggage claim carousel, and several rental car agencies.
• The airport, sometimes called Mark Andrews International Airport after Mark Andrews, a former U.S.
• On October 3, 2012, United Airlines started flights between Denver, CO and Grand Forks, but on September 10, 2013 they announced they would end service on December 3, 2013 citing low loads.
• A unique attribute of KGFK is that it is the University of North Dakota’s Aerospace program.
• The furthest airport from Grand Forks International Airport (GFK) is Margaret River Airport (MGV), which is located 10,514 miles (16,921 kilometers) away in Margaret River, Western Australia, Australia.
• Because of Grand Forks International Airport's relatively low elevation of 845 feet, planes can take off or land at Grand Forks International Airport at a lower air speed than at airports located at a higher elevation. This is because the air density is higher closer to sea level than it would otherwise be at higher elevations.
• The now closed original passenger terminal at GFK was built in 1964.
• The closest airport to Grand Forks International Airport (GFK) is Grand Forks Air Force Base (RDR), which is located only 10 miles (17 kilometers) W of GFK.
• In the mid-2000s, discussion began of upgrading or totally replacing the terminal as it has structural and safety problems and leaves little to no room for expansion.

Facts about Decatur County Industrial Air Park (BGE):

• Following entry of the United States into World War II, the Chief of the Army Air Corps directed the Air Corps Flying Training Command Southeast Training Center to immediately take action to select air base sites needed to increase its pilot training rate to meet anticipated wartime demands.
• The contractor broke ground on 3 April 1942, for Bainbridge Army Airfield.
• Because of Decatur County Industrial Air Park's relatively low elevation of 141 feet, planes can take off or land at Decatur County Industrial Air Park at a lower air speed than at airports located at a higher elevation. This is because the air density is higher closer to sea level than it would otherwise be at higher elevations.
• Decatur County Industrial Air Park (BGE) has 2 runways.
• The furthest airport from Decatur County Industrial Air Park (BGE) is Kalbarri Airport (KAX), which is located 11,278 miles (18,150 kilometers) away in Kalbarri, Western Australia, Australia.
• The closest airport to Decatur County Industrial Air Park (BGE) is Tallahassee Regional Airport (TLH), which is located 43 miles (70 kilometers) SSE of BGE.
• Today, Bainbridge is used for various purposes in addition to a small amount of aviation activity.