Nonstop flight route between Grand Forks, North Dakota, United States and Bainbridge, Georgia, United States:

About this route:

A direct, nonstop flight between Grand Forks Air Force Base (RDR), Grand Forks, North Dakota, United States and Decatur County Industrial Air Park (BGE), Bainbridge, Georgia, United States would travel a Great Circle distance of 1,353 miles (or 2,177 kilometers).

A Great Circle is the shortest distance between 2 points on a sphere. Because most world maps are flat (but the Earth is round), the route of the shortest distance between 2 points on the Earth will often appear curved when viewed on a flat map, especially for long distances. If you were to simply draw a straight line on a flat map and measure a very long distance, it would likely be much further than if you were to lay a string between those two points on a globe. Because of the relatively short distance between Grand Forks Air Force Base and Decatur County Industrial Air Park, the route shown on this map most likely still appears to be a straight line.

Departure Airport Information:

Arrival Airport Information:

Facts about Grand Forks Air Force Base (RDR):

• In addition to the interceptor squadrons, a Semi Automatic Ground Environment Data Center was established at Grand Forks in 1958.
• The closest airport to Grand Forks Air Force Base (RDR) is Grand Forks International Airport (GFK), which is located only 10 miles (17 kilometers) E of RDR.
• During the Cold War, GFAFB was a major installation of the Strategic Air Command, with B-52 bombers, KC-135 tankers, and Minuteman intercontinental ballistic missiles.
• The furthest airport from Grand Forks Air Force Base (RDR) is Margaret River Airport (MGV), which is located 10,504 miles (16,904 kilometers) away in Margaret River, Western Australia, Australia.
• On 18 February 1957, the 478th Fighter Group was activated at Grand Forks.
• On 1 November 1964, 321st Strategic Missile Wing was organized as the Minuteman II intercontinental ballistic missile wing at GFAFB, the first in SAC.
• In October 1977, the PAR came under operational control of the USAF, which operated it thereafter as part of its early warning system.
• On 3 November 1967, the Department of Defense revealed that GFAFB was one of 10 initial locations to host a Sentinel Anti-Ballistic Missile site.
• In addition to being known as "Grand Forks Air Force Base", another name for RDR is "Grand Forks AFB".

Facts about Decatur County Industrial Air Park (BGE):

• The furthest airport from Decatur County Industrial Air Park (BGE) is Kalbarri Airport (KAX), which is located 11,278 miles (18,150 kilometers) away in Kalbarri, Western Australia, Australia.
• Decatur County Industrial Air Park (BGE) has 2 runways.
• The closest airport to Decatur County Industrial Air Park (BGE) is Tallahassee Regional Airport (TLH), which is located 43 miles (70 kilometers) SSE of BGE.
• Because of Decatur County Industrial Air Park's relatively low elevation of 141 feet, planes can take off or land at Decatur County Industrial Air Park at a lower air speed than at airports located at a higher elevation. This is because the air density is higher closer to sea level than it would otherwise be at higher elevations.
• There was little need, however, for the airfield, and in the immediate postwar years, farmers leased the open areas of the airfield for cultivation and the cantonment area was used for various purposes.
• Following entry of the United States into World War II, the Chief of the Army Air Corps directed the Air Corps Flying Training Command Southeast Training Center to immediately take action to select air base sites needed to increase its pilot training rate to meet anticipated wartime demands.