Nonstop flight route between Rochester, New York, United States and Bainbridge, Georgia, United States:

About this route:

A direct, nonstop flight between Greater Rochester International Airport (ROC), Rochester, New York, United States and Decatur County Industrial Air Park (BGE), Bainbridge, Georgia, United States would travel a Great Circle distance of 922 miles (or 1,484 kilometers).

A Great Circle is the shortest distance between 2 points on a sphere. Because most world maps are flat (but the Earth is round), the route of the shortest distance between 2 points on the Earth will often appear curved when viewed on a flat map, especially for long distances. If you were to simply draw a straight line on a flat map and measure a very long distance, it would likely be much further than if you were to lay a string between those two points on a globe. Because of the relatively short distance between Greater Rochester International Airport and Decatur County Industrial Air Park, the route shown on this map most likely still appears to be a straight line.

Departure Airport Information:

Arrival Airport Information:

Facts about Greater Rochester International Airport (ROC):

• Greater Rochester International Airport (ROC) has 3 runways.
• The County got as far as building temporary parking lots to the west and closing the main parking lots to begin construction on a garage.
• The furthest airport from Greater Rochester International Airport (ROC) is Margaret River Airport (MGV), which is located 11,501 miles (18,509 kilometers) away in Margaret River, Western Australia, Australia.
• In 2008 renovations were undertaken to replace floors, carpets, and seating in the concourses, move explosives-scanning equipment from the ticketing lobby to the outbound baggage room, and replace 't' shaped baggage claim carousels with 360-degree walk-around carousels which receive luggage from belts through the ceiling.
• The closest airport to Greater Rochester International Airport (ROC) is Dansville Municipal Airport (DSV), which is located 38 miles (61 kilometers) S of ROC.
• Jet service began ROC in 1965 on American Airlines Boeing 727s, but the two longest runways, 10–28 and 1–19 were short for jets.
• Greater Rochester International Airport handled 2,533,834 passengers last year.
• Because of Greater Rochester International Airport's relatively low elevation of 559 feet, planes can take off or land at Greater Rochester International Airport at a lower air speed than at airports located at a higher elevation. This is because the air density is higher closer to sea level than it would otherwise be at higher elevations.
• The airport covers 1,136 acres at an elevation of 559 feet.

Facts about Decatur County Industrial Air Park (BGE):

• Decatur County Industrial Air Park (BGE) has 2 runways.
• There was little need, however, for the airfield, and in the immediate postwar years, farmers leased the open areas of the airfield for cultivation and the cantonment area was used for various purposes.
• Because of Decatur County Industrial Air Park's relatively low elevation of 141 feet, planes can take off or land at Decatur County Industrial Air Park at a lower air speed than at airports located at a higher elevation. This is because the air density is higher closer to sea level than it would otherwise be at higher elevations.
• The furthest airport from Decatur County Industrial Air Park (BGE) is Kalbarri Airport (KAX), which is located 11,278 miles (18,150 kilometers) away in Kalbarri, Western Australia, Australia.
• The closest airport to Decatur County Industrial Air Park (BGE) is Tallahassee Regional Airport (TLH), which is located 43 miles (70 kilometers) SSE of BGE.
• Following entry of the United States into World War II, the Chief of the Army Air Corps directed the Air Corps Flying Training Command Southeast Training Center to immediately take action to select air base sites needed to increase its pilot training rate to meet anticipated wartime demands.