Nonstop flight route between St. Louis, Missouri, United States and Bainbridge, Georgia, United States:

About this route:

A direct, nonstop flight between Lambert–St. Louis International Airport (STL), St. Louis, Missouri, United States and Decatur County Industrial Air Park (BGE), Bainbridge, Georgia, United States would travel a Great Circle distance of 627 miles (or 1,010 kilometers).

A Great Circle is the shortest distance between 2 points on a sphere. Because most world maps are flat (but the Earth is round), the route of the shortest distance between 2 points on the Earth will often appear curved when viewed on a flat map, especially for long distances. If you were to simply draw a straight line on a flat map and measure a very long distance, it would likely be much further than if you were to lay a string between those two points on a globe. Because of the relatively short distance between Lambert–St. Louis International Airport and Decatur County Industrial Air Park, the route shown on this map most likely still appears to be a straight line.

Departure Airport Information:

Arrival Airport Information:

Facts about Lambert–St. Louis International Airport (STL):

• The furthest airport from Lambert–St. Louis International Airport (STL) is Margaret River Airport (MGV), which is located 10,986 miles (17,681 kilometers) away in Margaret River, Western Australia, Australia.
• The closest airport to Lambert–St. Louis International Airport (STL) is St. Louis Downtown Airport (CPS), which is located only 16 miles (27 kilometers) SE of STL.
• In early October 2009, Southwest Airlines announced the addition of 6 daily flights to several cities it already served from St.
• After the war, NAS St.
• Lambert–St. Louis International Airport (STL) has 4 runways.
• American Airline's merger closed in April 2001, and the last TWA flight was flown on December 1, 2001.
• However, TWA faced increasing problems as overall airline demand softened in response to a softening overall economy.
• To handle the increasing passenger traffic, Minoru Yamasaki was commissioned to design a new terminal at Lambert.
• Because of Lambert–St. Louis International Airport's relatively low elevation of 605 feet, planes can take off or land at Lambert–St. Louis International Airport at a lower air speed than at airports located at a higher elevation. This is because the air density is higher closer to sea level than it would otherwise be at higher elevations.

Facts about Decatur County Industrial Air Park (BGE):

• During World War II, the airfield conducted flight training of new pilots by Army Air Forces Flying Training Command.
• The contractor broke ground on 3 April 1942, for Bainbridge Army Airfield.
• Because of Decatur County Industrial Air Park's relatively low elevation of 141 feet, planes can take off or land at Decatur County Industrial Air Park at a lower air speed than at airports located at a higher elevation. This is because the air density is higher closer to sea level than it would otherwise be at higher elevations.
• The furthest airport from Decatur County Industrial Air Park (BGE) is Kalbarri Airport (KAX), which is located 11,278 miles (18,150 kilometers) away in Kalbarri, Western Australia, Australia.
• Decatur County Industrial Air Park (BGE) has 2 runways.
• There was little need, however, for the airfield, and in the immediate postwar years, farmers leased the open areas of the airfield for cultivation and the cantonment area was used for various purposes.
• Following entry of the United States into World War II, the Chief of the Army Air Corps directed the Air Corps Flying Training Command Southeast Training Center to immediately take action to select air base sites needed to increase its pilot training rate to meet anticipated wartime demands.
• The closest airport to Decatur County Industrial Air Park (BGE) is Tallahassee Regional Airport (TLH), which is located 43 miles (70 kilometers) SSE of BGE.