Nonstop flight route between Christiansted, Saint Croix, United States Virgin Islands and Bainbridge, Georgia, United States:

About this route:

A direct, nonstop flight between Henry E. Rohlsen International Airport (STX), Christiansted, Saint Croix, United States Virgin Islands and Decatur County Industrial Air Park (BGE), Bainbridge, Georgia, United States would travel a Great Circle distance of 1,545 miles (or 2,486 kilometers).

A Great Circle is the shortest distance between 2 points on a sphere. Because most world maps are flat (but the Earth is round), the route of the shortest distance between 2 points on the Earth will often appear curved when viewed on a flat map, especially for long distances. If you were to simply draw a straight line on a flat map and measure a very long distance, it would likely be much further than if you were to lay a string between those two points on a globe. Because of the relatively short distance between Henry E. Rohlsen International Airport and Decatur County Industrial Air Park, the route shown on this map most likely still appears to be a straight line.

Departure Airport Information:

Arrival Airport Information:

Facts about Henry E. Rohlsen International Airport (STX):

• The closest airport to Henry E. Rohlsen International Airport (STX) is Christiansted Harbor Seaplane Base (SSB), which is located only 7 miles (11 kilometers) ENE of STX.
• During World War II, the United States Army Air Forces Sixth Air Force stationed the 12th Bombardment Squadron at the airport for antisubmarine patrols flying B-18 Bolo aircraft from November 8, 1941 to November 10, 1942.
• Because of Henry E. Rohlsen International Airport's relatively low elevation of 74 feet, planes can take off or land at Henry E. Rohlsen International Airport at a lower air speed than at airports located at a higher elevation. This is because the air density is higher closer to sea level than it would otherwise be at higher elevations.
• Henry E. Rohlsen International Airport (STX) currently has only 1 runway.
• The furthest airport from Henry E. Rohlsen International Airport (STX) is Barrow Island Airport (BWB), which is nearly antipodal to Henry E. Rohlsen International Airport (meaning Henry E. Rohlsen International Airport is almost on the exact opposite side of the Earth from Barrow Island Airport), and is located 12,218 miles (19,663 kilometers) away in Barrow Island, Western Australia, Australia.

Facts about Decatur County Industrial Air Park (BGE):

• The closest airport to Decatur County Industrial Air Park (BGE) is Tallahassee Regional Airport (TLH), which is located 43 miles (70 kilometers) SSE of BGE.
• The contractor broke ground on 3 April 1942, for Bainbridge Army Airfield.
• There was little need, however, for the airfield, and in the immediate postwar years, farmers leased the open areas of the airfield for cultivation and the cantonment area was used for various purposes.
• Because of Decatur County Industrial Air Park's relatively low elevation of 141 feet, planes can take off or land at Decatur County Industrial Air Park at a lower air speed than at airports located at a higher elevation. This is because the air density is higher closer to sea level than it would otherwise be at higher elevations.
• Decatur County Industrial Air Park (BGE) has 2 runways.
• The furthest airport from Decatur County Industrial Air Park (BGE) is Kalbarri Airport (KAX), which is located 11,278 miles (18,150 kilometers) away in Kalbarri, Western Australia, Australia.
• Following entry of the United States into World War II, the Chief of the Army Air Corps directed the Air Corps Flying Training Command Southeast Training Center to immediately take action to select air base sites needed to increase its pilot training rate to meet anticipated wartime demands.
• During World War II, the airfield conducted flight training of new pilots by Army Air Forces Flying Training Command.