Nonstop flight route between Stuttgart, Germany and Teterboro, New Jersey, United States:

About this route:

A direct, nonstop flight between Stuttgart Hauptbahnhof (ZWS), Stuttgart, Germany and Teterboro Airport (TEB), Teterboro, New Jersey, United States would travel a Great Circle distance of 3,910 miles (or 6,292 kilometers).

A Great Circle is the shortest distance between 2 points on a sphere. Because most world maps are flat (but the Earth is round), the route of the shortest distance between 2 points on the Earth will often appear curved when viewed on a flat map, especially for long distances. If you were to simply draw a straight line on a flat map and measure a very long distance, it would likely be much further than if you were to lay a string between those two points on a globe. Because of the large distance between Stuttgart Hauptbahnhof and Teterboro Airport, the route shown on this map most likely appears curved because of this reason.

Try it at home! Get a globe and tightly lay a string between Stuttgart Hauptbahnhof and Teterboro Airport. You'll see that it will travel the same route of the red line on this map!

Departure Airport Information:

Arrival Airport Information:

Facts about Stuttgart Hauptbahnhof (ZWS):

• Due to increasing railway traffic, the first building was replaced by new construction in the same spot in the 1860s.
• The furthest airport from Stuttgart Hauptbahnhof (ZWS) is Chatham Islands (CHT), which is nearly antipodal to Stuttgart Hauptbahnhof (meaning Stuttgart Hauptbahnhof is almost on the exact opposite side of the Earth from Chatham Islands), and is located 12,001 miles (19,313 kilometers) away in Waitangi, Chatham Islands, New Zealand.
• The Stuttgart architect and Bonatz expert Matthias Roser initiated an international call for the preservation of the Hauptbahnhof, including the wings, and over 400 architects, building historians, monument conservators, art historians, and city planners, such as the Pritzger Prize recipient Richard Meier or David Chipperfield, have joined this effort.
• On 15 May 1933, the electrification of all 17 tracks was completed.
• Because of Stuttgart Hauptbahnhof's relatively low elevation of 0 feet, planes can take off or land at Stuttgart Hauptbahnhof at a lower air speed than at airports located at a higher elevation. This is because the air density is higher closer to sea level than it would otherwise be at higher elevations.
• The station building was constructed using reinforced concrete, which was then covered with roughly hewn shell limestone ashlar, sourced from the area around Crailsheim.
• The closest airport to Stuttgart Hauptbahnhof (ZWS) is Stuttgart Airport (STR), which is located only 7 miles (11 kilometers) SSE of ZWS.

Facts about Teterboro Airport (TEB):

• Teterboro Airport (TEB) has 2 runways.
• Nineteen hangars on the airport have a total area of about 412,000 square feet.
• During World War II, the United States Army operated the airport.
• The control tower was built on the east side of the airport by the FAA and went into operation on October 29, 1975.
• The furthest airport from Teterboro Airport (TEB) is Margaret River Airport (MGV), which is located 11,744 miles (18,900 kilometers) away in Margaret River, Western Australia, Australia.
• The closest airport to Teterboro Airport (TEB) is West 30th Street Heliport (JRA), which is located only 7 miles (12 kilometers) SSE of TEB.
• In June 1966, in Hasbrouck Heights, a 2 engine, Piper Aztec going to Teterboro Airport crashed, striking a tree and narrowly missing homes on Burton Avenue near Route 46.
• Because of Teterboro Airport's relatively low elevation of 9 feet, planes can take off or land at Teterboro Airport at a lower air speed than at airports located at a higher elevation. This is because the air density is higher closer to sea level than it would otherwise be at higher elevations.
• In January 1954 Arthur Godfrey buzzed the Teterboro control tower with his Douglas DC-3, resulting in the suspension of his license.
• Runway 1-19 is 7,000 feet long and 150 feet wide, with HIRL.