Nonstop flight route between Burbank, California, United States and Bennettsville, South Carolina, United States:
Departure Airport:
Arrival Airport:
Distance from BUR to BTN:
Share this route:
Jump to:
- About this route
- BUR Airport Information
- BTN Airport Information
- Facts about BUR
- Facts about BTN
- Map of Nearest Airports to BUR
- List of Nearest Airports to BUR
- Map of Furthest Airports from BUR
- List of Furthest Airports from BUR
- Map of Nearest Airports to BTN
- List of Nearest Airports to BTN
- Map of Furthest Airports from BTN
- List of Furthest Airports from BTN
About this route:
A direct, nonstop flight between Bob Hope Airport (BUR), Burbank, California, United States and Marlboro County Jetport (BTN), Bennettsville, South Carolina, United States would travel a Great Circle distance of 2,188 miles (or 3,521 kilometers).
A Great Circle is the shortest distance between 2 points on a sphere. Because most world maps are flat (but the Earth is round), the route of the shortest distance between 2 points on the Earth will often appear curved when viewed on a flat map, especially for long distances. If you were to simply draw a straight line on a flat map and measure a very long distance, it would likely be much further than if you were to lay a string between those two points on a globe. Because of the relatively short distance between Bob Hope Airport and Marlboro County Jetport, the route shown on this map most likely still appears to be a straight line.
Departure Airport Information:
| IATA / ICAO Codes: | BUR / KBUR |
| Airport Names: |
|
| Location: | Burbank, California, United States |
| GPS Coordinates: | 34°12'2"N by 118°21'30"W |
| Area Served: | Los Angeles Area |
| Airport Type: | Public |
| Elevation: | 778 feet (237 meters) |
| # of Runways: | 2 |
| View all routes: | Routes from BUR |
| More Information: | BUR Maps & Info |
Arrival Airport Information:
| IATA / ICAO Codes: | BTN / KBBP |
| Airport Names: |
|
| Location: | Bennettsville, South Carolina, United States |
| GPS Coordinates: | 34°37'18"N by 79°44'3"W |
| Area Served: | Bennettsville, South Carolina |
| Operator/Owner: | Marlboro County |
| Airport Type: | Public |
| Elevation: | 147 feet (45 meters) |
| # of Runways: | 1 |
| View all routes: | Routes from BTN |
| More Information: | BTN Maps & Info |
Facts about Bob Hope Airport (BUR):
- The airport is owned by the Burbank-Glendale-Pasadena Airport Authority, controlled by the governments of those cities.
- United Airport was dedicated amid much festivity on Memorial Day weekend, 1930.
- No municipal bus service is offered direct to the terminal building, however, the MTA provides bus service to the corner of Hollywood Way and Thornton Ave via lines 94, 169, 222, and 794.
- The land occupied by the old Lockheed buildings at the corners of Empire Avenue and Hollywood Way and Thornton Avenue, is now the site of a growing power center commercial development with chain restaurants and businesses.
- Because of Bob Hope Airport's relatively low elevation of 778 feet, planes can take off or land at Bob Hope Airport at a lower air speed than at airports located at a higher elevation. This is because the air density is higher closer to sea level than it would otherwise be at higher elevations.
- The furthest airport from Bob Hope Airport (BUR) is Pierrefonds Airport (ZSE), which is located 11,470 miles (18,459 kilometers) away in Saint-Pierre, Réunion.
- The closest airport to Bob Hope Airport (BUR) is Whiteman Airport (WHP), which is located only 5 miles (8 kilometers) NW of BUR.
- Bob Hope Airport (BUR) has 2 runways.
- Lockheed officials declared that the airport would reopen the next day, and it did, using electronic equipment borrowed from LAX and set up in a nearby hangar.
- In addition to being known as "Bob Hope Airport", another name for BUR is "(former Lockheed Air Terminal)".
Facts about Marlboro County Jetport (BTN):
- Because of Marlboro County Jetport's relatively low elevation of 147 feet, planes can take off or land at Marlboro County Jetport at a lower air speed than at airports located at a higher elevation. This is because the air density is higher closer to sea level than it would otherwise be at higher elevations.
- In addition to being known as "Marlboro County Jetport", other names for BTN include "H.E. Avent Field" and "BBP".
- The furthest airport from Marlboro County Jetport (BTN) is Margaret River Airport (MGV), which is located 11,589 miles (18,651 kilometers) away in Margaret River, Western Australia, Australia.
- Marlboro County Jetport covers an area of 175 acres at an elevation of 147 feet above mean sea level.
- Marlboro County Jetport (BTN) currently has only 1 runway.
- The closest airport to Marlboro County Jetport (BTN) is Cheraw Municipal Airport (HCW), which is located only 14 miles (23 kilometers) WNW of BTN.
