Nonstop flight route between Sundsvall, Sweden and Bainbridge, Georgia, United States:

About this route:

A direct, nonstop flight between Sundsvall–Timrå Airport (SDL), Sundsvall, Sweden and Decatur County Industrial Air Park (BGE), Bainbridge, Georgia, United States would travel a Great Circle distance of 4,702 miles (or 7,567 kilometers).

A Great Circle is the shortest distance between 2 points on a sphere. Because most world maps are flat (but the Earth is round), the route of the shortest distance between 2 points on the Earth will often appear curved when viewed on a flat map, especially for long distances. If you were to simply draw a straight line on a flat map and measure a very long distance, it would likely be much further than if you were to lay a string between those two points on a globe. Because of the large distance between Sundsvall–Timrå Airport and Decatur County Industrial Air Park, the route shown on this map most likely appears curved because of this reason.

Try it at home! Get a globe and tightly lay a string between Sundsvall–Timrå Airport and Decatur County Industrial Air Park. You'll see that it will travel the same route of the red line on this map!

Departure Airport Information:

Arrival Airport Information:

Facts about Sundsvall–Timrå Airport (SDL):

• Because of Sundsvall–Timrå Airport's relatively low elevation of 16 feet, planes can take off or land at Sundsvall–Timrå Airport at a lower air speed than at airports located at a higher elevation. This is because the air density is higher closer to sea level than it would otherwise be at higher elevations.
• The furthest airport from Sundsvall–Timrå Airport (SDL) is Chatham Islands (CHT), which is located 11,028 miles (17,748 kilometers) away in Waitangi, Chatham Islands, New Zealand.
• The closest airport to Sundsvall–Timrå Airport (SDL) is Örnsköldsvik Airport (OER), which is located 78 miles (125 kilometers) NE of SDL.
• Sundsvall–Timrå Airport (SDL) currently has only 1 runway.

Facts about Decatur County Industrial Air Park (BGE):

• During World War II, the airfield conducted flight training of new pilots by Army Air Forces Flying Training Command.
• There was little need, however, for the airfield, and in the immediate postwar years, farmers leased the open areas of the airfield for cultivation and the cantonment area was used for various purposes.
• Decatur County Industrial Air Park (BGE) has 2 runways.
• The closest airport to Decatur County Industrial Air Park (BGE) is Tallahassee Regional Airport (TLH), which is located 43 miles (70 kilometers) SSE of BGE.
• The contractor broke ground on 3 April 1942, for Bainbridge Army Airfield.
• Because of Decatur County Industrial Air Park's relatively low elevation of 141 feet, planes can take off or land at Decatur County Industrial Air Park at a lower air speed than at airports located at a higher elevation. This is because the air density is higher closer to sea level than it would otherwise be at higher elevations.
• The furthest airport from Decatur County Industrial Air Park (BGE) is Kalbarri Airport (KAX), which is located 11,278 miles (18,150 kilometers) away in Kalbarri, Western Australia, Australia.