Nonstop flight route between Filton, Bristol, United Kingdom and East Hartford, Connecticut, United States:

About this route:

A direct, nonstop flight between Bristol Filton Airport (FZO), Filton, Bristol, United Kingdom and Rentschler Heliport (EHT), East Hartford, Connecticut, United States would travel a Great Circle distance of 3,259 miles (or 5,245 kilometers).

A Great Circle is the shortest distance between 2 points on a sphere. Because most world maps are flat (but the Earth is round), the route of the shortest distance between 2 points on the Earth will often appear curved when viewed on a flat map, especially for long distances. If you were to simply draw a straight line on a flat map and measure a very long distance, it would likely be much further than if you were to lay a string between those two points on a globe. Because of the large distance between Bristol Filton Airport and Rentschler Heliport, the route shown on this map most likely appears curved because of this reason.

Try it at home! Get a globe and tightly lay a string between Bristol Filton Airport and Rentschler Heliport. You'll see that it will travel the same route of the red line on this map!

Departure Airport Information:

Arrival Airport Information:

Facts about Bristol Filton Airport (FZO):

• Because of Bristol Filton Airport's relatively low elevation of 225 feet, planes can take off or land at Bristol Filton Airport at a lower air speed than at airports located at a higher elevation. This is because the air density is higher closer to sea level than it would otherwise be at higher elevations.
• The furthest airport from Bristol Filton Airport (FZO) is Dunedin International Airport (DUD), which is located 11,930 miles (19,200 kilometers) away in Dunedin, Otago, New Zealand.
• Aircraft produced during WWII included the Blenheim, Beaufort, Beaufighter and Brigand.
• Filton's runway is one of the widest, at 91 m and is a considerable length at 2,467 m long, having been extended first for the maiden flight of the Bristol Brabazon airliner in 1949 and again in the late 1960s for Concorde.
• The closest airport to Bristol Filton Airport (FZO) is Bristol Airport (BRS), which is located only 11 miles (18 kilometers) SSW of FZO.
• A flying school was located on the northern side of the airfield.
• Before D-Day, US-manufactured aircraft were assembled at Filton Aerodrome, from assemblies imported via Avonmouth docks.
• During World War I, RFC Filton was mainly used as an aircraft acceptance facility.
• In addition to being known as "Bristol Filton Airport", another name for FZO is "Filton Aerodrome".
• After WW2, the concrete runway at Filton Aerodrome was extended westwards to enable the huge Bristol Brabazon airliner to take-off safely.
• Bristol Filton Airport (FZO) currently has only 1 runway.
• The 1960s and 1970s saw the development and production of Concorde at Filton and a further extension of the Filton runway.
• The three-bay Brabazon Hangar was built in the late 1940s under the direction of T.

Facts about Rentschler Heliport (EHT):

• The closest airport to Rentschler Heliport (EHT) is Hartford-Brainard Airport (HFD), which is located only 2 miles (3 kilometers) SW of EHT.
• Because of Rentschler Heliport's relatively low elevation of 48 feet, planes can take off or land at Rentschler Heliport at a lower air speed than at airports located at a higher elevation. This is because the air density is higher closer to sea level than it would otherwise be at higher elevations.
• This former airfield was located only a few miles northeast of still-operational Hartford Brainard Airport.
• In addition to being known as "Rentschler Heliport", another name for EHT is "CT88".
• As of 2006, the only remaining aviation use on the site was the Rentschler Heliport, a private facility operated by Pratt & Whitney.
• The furthest airport from Rentschler Heliport (EHT) is Margaret River Airport (MGV), which is located 11,752 miles (18,913 kilometers) away in Margaret River, Western Australia, Australia.