Nonstop flight route between Great Falls, Montana, United States and Bainbridge, Georgia, United States:

About this route:

A direct, nonstop flight between Great Falls International Airport (GTF), Great Falls, Montana, United States and Decatur County Industrial Air Park (BGE), Bainbridge, Georgia, United States would travel a Great Circle distance of 1,814 miles (or 2,920 kilometers).

A Great Circle is the shortest distance between 2 points on a sphere. Because most world maps are flat (but the Earth is round), the route of the shortest distance between 2 points on the Earth will often appear curved when viewed on a flat map, especially for long distances. If you were to simply draw a straight line on a flat map and measure a very long distance, it would likely be much further than if you were to lay a string between those two points on a globe. Because of the relatively short distance between Great Falls International Airport and Decatur County Industrial Air Park, the route shown on this map most likely still appears to be a straight line.

Departure Airport Information:

Arrival Airport Information:

Facts about Great Falls International Airport (GTF):

• The furthest airport from Great Falls International Airport (GTF) is Sir Gaëtan Duval Airport (RRG), which is located 10,498 miles (16,896 kilometers) away in Rodrigues Island, Mauritius.
• In 1975 the terminal was replaced and all runways, aprons, and taxiways updated.
• In addition to being known as "Great Falls International Airport", another name for GTF is "(former Great Falls Army Airfield)".
• Great Falls has had airline flights since the 1930s.
• The closest airport to Great Falls International Airport (GTF) is Malmstrom Air Force Base (GFA), which is located only 9 miles (14 kilometers) E of GTF.
• Great Falls International Airport (GTF) has 3 runways.

Facts about Decatur County Industrial Air Park (BGE):

• Today, Bainbridge is used for various purposes in addition to a small amount of aviation activity.
• As a result of the Korean War which began in 1950 and the expansion of the United States Air Force, Bainbridge Air Base* was reopened to train additional pilots.
• Because of Decatur County Industrial Air Park's relatively low elevation of 141 feet, planes can take off or land at Decatur County Industrial Air Park at a lower air speed than at airports located at a higher elevation. This is because the air density is higher closer to sea level than it would otherwise be at higher elevations.
• The furthest airport from Decatur County Industrial Air Park (BGE) is Kalbarri Airport (KAX), which is located 11,278 miles (18,150 kilometers) away in Kalbarri, Western Australia, Australia.
• During World War II, the airfield conducted flight training of new pilots by Army Air Forces Flying Training Command.
• Following entry of the United States into World War II, the Chief of the Army Air Corps directed the Air Corps Flying Training Command Southeast Training Center to immediately take action to select air base sites needed to increase its pilot training rate to meet anticipated wartime demands.
• Decatur County Industrial Air Park (BGE) has 2 runways.
• The closest airport to Decatur County Industrial Air Park (BGE) is Tallahassee Regional Airport (TLH), which is located 43 miles (70 kilometers) SSE of BGE.