Nonstop flight route between Flanders, Belgium and Bainbridge, Georgia, United States:

About this route:

A direct, nonstop flight between Ostend-Bruges International Airport (OST), Flanders, Belgium and Decatur County Industrial Air Park (BGE), Bainbridge, Georgia, United States would travel a Great Circle distance of 4,483 miles (or 7,215 kilometers).

A Great Circle is the shortest distance between 2 points on a sphere. Because most world maps are flat (but the Earth is round), the route of the shortest distance between 2 points on the Earth will often appear curved when viewed on a flat map, especially for long distances. If you were to simply draw a straight line on a flat map and measure a very long distance, it would likely be much further than if you were to lay a string between those two points on a globe. Because of the large distance between Ostend-Bruges International Airport and Decatur County Industrial Air Park, the route shown on this map most likely appears curved because of this reason.

Try it at home! Get a globe and tightly lay a string between Ostend-Bruges International Airport and Decatur County Industrial Air Park. You'll see that it will travel the same route of the red line on this map!

Departure Airport Information:

Arrival Airport Information:

Facts about Ostend-Bruges International Airport (OST):

• The closest airport to Ostend-Bruges International Airport (OST) is Dunkerque – Les Moëres Airfield (XDK), which is located only 17 miles (28 kilometers) SW of OST.
• The furthest airport from Ostend-Bruges International Airport (OST) is Chatham Islands (CHT), which is located 11,925 miles (19,192 kilometers) away in Waitangi, Chatham Islands, New Zealand.
• Ostend-Bruges International Airport (OST) currently has only 1 runway.
• On 1 May 2003, Ryanair started a new route between Ostend and London-Stansted.
• In 1992, the ownership of the regional Flemish airport was transferred from the Belgian State to the Flemish Region.
• Because of Ostend-Bruges International Airport's relatively low elevation of 13 feet, planes can take off or land at Ostend-Bruges International Airport at a lower air speed than at airports located at a higher elevation. This is because the air density is higher closer to sea level than it would otherwise be at higher elevations.
• Ostend-Bruges International Airport handled 678,638 passengers last year.

Facts about Decatur County Industrial Air Park (BGE):

• Today, Bainbridge is used for various purposes in addition to a small amount of aviation activity.
• During World War II, the airfield conducted flight training of new pilots by Army Air Forces Flying Training Command.
• Because of Decatur County Industrial Air Park's relatively low elevation of 141 feet, planes can take off or land at Decatur County Industrial Air Park at a lower air speed than at airports located at a higher elevation. This is because the air density is higher closer to sea level than it would otherwise be at higher elevations.
• The closest airport to Decatur County Industrial Air Park (BGE) is Tallahassee Regional Airport (TLH), which is located 43 miles (70 kilometers) SSE of BGE.
• Decatur County Industrial Air Park (BGE) has 2 runways.
• Following entry of the United States into World War II, the Chief of the Army Air Corps directed the Air Corps Flying Training Command Southeast Training Center to immediately take action to select air base sites needed to increase its pilot training rate to meet anticipated wartime demands.
• The furthest airport from Decatur County Industrial Air Park (BGE) is Kalbarri Airport (KAX), which is located 11,278 miles (18,150 kilometers) away in Kalbarri, Western Australia, Australia.
• Through the years a lot of material has been gathered about the Southern Airways School and Bainbridge Air Base.