Nonstop flight route between San Antonio, Texas, United States and Bainbridge, Georgia, United States:

About this route:

A direct, nonstop flight between Lackland Air Force Base Joint Base San Antonio (SKF), San Antonio, Texas, United States and Decatur County Industrial Air Park (BGE), Bainbridge, Georgia, United States would travel a Great Circle distance of 839 miles (or 1,351 kilometers).

A Great Circle is the shortest distance between 2 points on a sphere. Because most world maps are flat (but the Earth is round), the route of the shortest distance between 2 points on the Earth will often appear curved when viewed on a flat map, especially for long distances. If you were to simply draw a straight line on a flat map and measure a very long distance, it would likely be much further than if you were to lay a string between those two points on a globe. Because of the relatively short distance between Lackland Air Force Base Joint Base San Antonio and Decatur County Industrial Air Park, the route shown on this map most likely still appears to be a straight line.

Departure Airport Information:

Arrival Airport Information:

Facts about Lackland Air Force Base Joint Base San Antonio (SKF):

• The closest airport to Lackland Air Force Base Joint Base San Antonio (SKF) is Stinson Municipal Airport (SSF), which is located only 7 miles (12 kilometers) ESE of SKF.
• In addition, with the closure of Kelly AFB Lackland gained the section of base known as Security Hill.
• The furthest airport from Lackland Air Force Base Joint Base San Antonio (SKF) is Sir Gaëtan Duval Airport (RRG), which is located 11,124 miles (17,902 kilometers) away in Rodrigues Island, Mauritius.
• In 1965 AN/FPS-20A was upgraded to an AN/FPS-91A radar, then in 1969 it was modified to an AN/FPS-66A.
• As a result of the Korean War, training populations at Lackland soared to 28 basic military training squadrons within the 3700th Military Training Wing.
• Lackland, like many other Air Education and Training Command bases, trains enlisted airmen out of basic training in a specific specialty via various "tech schools." Lackland currently has six technical training squadrons on base training multiple airmen in various Air Force Specialty Codes.
• In October 2008 the BMT was expanded an extra two weeks to implement more air base defense training as well as other rudimentary skills.

Facts about Decatur County Industrial Air Park (BGE):

• Because of Decatur County Industrial Air Park's relatively low elevation of 141 feet, planes can take off or land at Decatur County Industrial Air Park at a lower air speed than at airports located at a higher elevation. This is because the air density is higher closer to sea level than it would otherwise be at higher elevations.
• During World War II, the airfield conducted flight training of new pilots by Army Air Forces Flying Training Command.
• The closest airport to Decatur County Industrial Air Park (BGE) is Tallahassee Regional Airport (TLH), which is located 43 miles (70 kilometers) SSE of BGE.
• Decatur County Industrial Air Park (BGE) has 2 runways.
• Today, Bainbridge is used for various purposes in addition to a small amount of aviation activity.
• Following entry of the United States into World War II, the Chief of the Army Air Corps directed the Air Corps Flying Training Command Southeast Training Center to immediately take action to select air base sites needed to increase its pilot training rate to meet anticipated wartime demands.
• The furthest airport from Decatur County Industrial Air Park (BGE) is Kalbarri Airport (KAX), which is located 11,278 miles (18,150 kilometers) away in Kalbarri, Western Australia, Australia.