Nonstop flight route between Seletar, Singapore and Gillette, Wyoming, United States:

About this route:

A direct, nonstop flight between Seletar Airport (XSP), Seletar, Singapore and Gillette–Campbell County Airport (GCC), Gillette, Wyoming, United States would travel a Great Circle distance of 8,793 miles (or 14,151 kilometers).

A Great Circle is the shortest distance between 2 points on a sphere. Because most world maps are flat (but the Earth is round), the route of the shortest distance between 2 points on the Earth will often appear curved when viewed on a flat map, especially for long distances. If you were to simply draw a straight line on a flat map and measure a very long distance, it would likely be much further than if you were to lay a string between those two points on a globe. Because of the large distance between Seletar Airport and Gillette–Campbell County Airport, the route shown on this map most likely appears curved because of this reason.

Try it at home! Get a globe and tightly lay a string between Seletar Airport and Gillette–Campbell County Airport. You'll see that it will travel the same route of the red line on this map!

Departure Airport Information:

Arrival Airport Information:

Facts about Seletar Airport (XSP):

• In addition to being known as "Seletar Airport", other names for XSP include "实里达机场" and "செலட்டர் வான்முகம்".
• Seletar Airport (XSP) currently has only 1 runway.
• Seletar Airport is a civilian airport located at Seletar, in the northeastern region of Singapore, and is managed by the Changi Airport Group.
• The closest airport to Seletar Airport (XSP) is Paya Lebar Air Base (PLAB) (QPG), which is located only 5 miles (8 kilometers) SE of XSP.
• After World War II, the base went back to the RAF and, in the late 1940s and 1950s, the base was heavily involved in the Malayan Emergency, with Beaufighters, Spitfires and Mosquitos based there while operating against Malayan Communist insurgents.
• Among Seletar’s claim to fame was that several classic aircraft type flew their last RAF Operational sorties from there including the Short Singapore flying boat,Supermarine Spitfire, De Havilland Mosquito, Short Sunderland flying boat and Bristol Beaufighter.
• Because of Seletar Airport's relatively low elevation of 36 feet, planes can take off or land at Seletar Airport at a lower air speed than at airports located at a higher elevation. This is because the air density is higher closer to sea level than it would otherwise be at higher elevations.
• The furthest airport from Seletar Airport (XSP) is Francisco de Orellana Airport (OCC), which is nearly antipodal to Seletar Airport (meaning Seletar Airport is almost on the exact opposite side of the Earth from Francisco de Orellana Airport), and is located 12,348 miles (19,873 kilometers) away in Coca, Ecuador.
• Vickers Vildebeest Mk IIs, K2918 and K2921, of 'A' Flight, No.
• The same Mitsubishi J2M Raiden fighters being test flown by Japanese naval aviators under close supervision of RAF officers from Seletar.
• There had been a proposal to extend its runway to 2,000 metres, so as to be able to receive the Boeing 737 used by many budget airlines.

Facts about Gillette–Campbell County Airport (GCC):

• Because of Gillette–Campbell County Airport's high elevation of 4,364 feet, planes must typically fly at a faster airspeed in order to takeoff or land at GCC. Combined with a high temperature, this could make GCC a "Hot & High" airport, where the air density is lower than it would otherwise be at sea level.
• The closest airport to Gillette–Campbell County Airport (GCC) is Sheridan County Airport (SHR), which is located 77 miles (123 kilometers) WNW of GCC.
• Gillette–Campbell County Airport (GCC) has 2 runways.
• Gillette–Campbell County Airport is five miles northwest of Gillette in Campbell County, Wyoming.
• The furthest airport from Gillette–Campbell County Airport (GCC) is Sir Gaëtan Duval Airport (RRG), which is located 10,622 miles (17,094 kilometers) away in Rodrigues Island, Mauritius.