Nonstop flight route between Seletar, Singapore and Bainbridge, Georgia, United States:

About this route:

A direct, nonstop flight between Seletar Airport (XSP), Seletar, Singapore and Decatur County Industrial Air Park (BGE), Bainbridge, Georgia, United States would travel a Great Circle distance of 10,130 miles (or 16,303 kilometers).

A Great Circle is the shortest distance between 2 points on a sphere. Because most world maps are flat (but the Earth is round), the route of the shortest distance between 2 points on the Earth will often appear curved when viewed on a flat map, especially for long distances. If you were to simply draw a straight line on a flat map and measure a very long distance, it would likely be much further than if you were to lay a string between those two points on a globe. Because of the large distance between Seletar Airport and Decatur County Industrial Air Park, the route shown on this map most likely appears curved because of this reason.

Try it at home! Get a globe and tightly lay a string between Seletar Airport and Decatur County Industrial Air Park. You'll see that it will travel the same route of the red line on this map!

Departure Airport Information:

Arrival Airport Information:

Facts about Seletar Airport (XSP):

• The furthest airport from Seletar Airport (XSP) is Francisco de Orellana Airport (OCC), which is nearly antipodal to Seletar Airport (meaning Seletar Airport is almost on the exact opposite side of the Earth from Francisco de Orellana Airport), and is located 12,348 miles (19,873 kilometers) away in Coca, Ecuador.
• Seletar Airport (XSP) currently has only 1 runway.
• During the Japanese occupation, Seletar as was in the case of Sembawang came under the Imperial Japanese Navy Air Service while Tengah fell under the jurisdiction of the Imperial Japanese Army Air Force.
• The closest airport to Seletar Airport (XSP) is Paya Lebar Air Base (PLAB) (QPG), which is located only 5 miles (8 kilometers) SE of XSP.
• The formative years of the SADC was established at Seletar Airbase in September 1968, with the setting up of the Flying Training School utilising three Cessna 172G/H on loan from the Singapore Flying Club.
• In addition to being known as "Seletar Airport", other names for XSP include "实里达机场" and "செலட்டர் வான்முகம்".
• During the 1960s, RAF Seletar was home base to No's 103 and 110 Squadrons, both of which were equipped with Westland Whirlwind Mk 10 helicopters and to 34 Squadron, which was equipped with Blackburn Beverleys.
• A 205 Sqn Short Sunderland Mark V ML797 "P" at the ramp of RAF Seletar, this particular airframe became the last of its type to retire from active RAF service on 30 June 1959.
• Previously Berjaya Air operated scheduled flights to Tioman and Redang.
• Because of Seletar Airport's relatively low elevation of 36 feet, planes can take off or land at Seletar Airport at a lower air speed than at airports located at a higher elevation. This is because the air density is higher closer to sea level than it would otherwise be at higher elevations.
• In 2007, JTC Corporation announced the plan to upgrade the Seletar Airport to support the upcoming Seletar Aerospace Park.

Facts about Decatur County Industrial Air Park (BGE):

• There was little need, however, for the airfield, and in the immediate postwar years, farmers leased the open areas of the airfield for cultivation and the cantonment area was used for various purposes.
• Decatur County Industrial Air Park (BGE) has 2 runways.
• During World War II, the airfield conducted flight training of new pilots by Army Air Forces Flying Training Command.
• Following entry of the United States into World War II, the Chief of the Army Air Corps directed the Air Corps Flying Training Command Southeast Training Center to immediately take action to select air base sites needed to increase its pilot training rate to meet anticipated wartime demands.
• The furthest airport from Decatur County Industrial Air Park (BGE) is Kalbarri Airport (KAX), which is located 11,278 miles (18,150 kilometers) away in Kalbarri, Western Australia, Australia.
• The closest airport to Decatur County Industrial Air Park (BGE) is Tallahassee Regional Airport (TLH), which is located 43 miles (70 kilometers) SSE of BGE.
• A level area near Bainbridge, seven miles northwest of the City adjacent to the Seaboard Air Line Railroad was selected by the Air Corps, and the City of Bainbridge and Decatur County purchased 2,070 acres for $66,800 and then leased the property to the Army for $1 per annum for a basic flight training base authorizing 89.9 million for its construction.
• Because of Decatur County Industrial Air Park's relatively low elevation of 141 feet, planes can take off or land at Decatur County Industrial Air Park at a lower air speed than at airports located at a higher elevation. This is because the air density is higher closer to sea level than it would otherwise be at higher elevations.